Pollution profiles and health risk assessment of VOCs emitted during e-waste dismantling processes associated with different dismantling methods.
نویسندگان
چکیده
Pollution profiles of typical volatile organic compounds (VOCs) emitted during dismantling of various printed circuit board assemblies (PCBAs) of e-wastes using different methods were comparatively investigated in the real e-waste dismantling workshops in South China in April 2013. Similar pollution profiles and concentrations of VOCs were observed between dismantling mobile phone and hard disk PCBAs by using electric blowers and between dismantling television and power supplier PCBAs using electric heating furnaces. Aromatic hydrocarbons (accounting for >60% of the sum of VOCs) were the dominant group during using electric blowers, while aromatic (accounting for >44% of the sum of VOCs) and halogenated hydrocarbons (accounting for >48% of the sum of VOCs) were the two dominant groups which contributed equally using electric heating furnaces. However, the distribution profiles of VOCs emitted during dismantling of televisions, hard disks and micro motors using rotary incinerators varied greatly, though aromatic hydrocarbons were still the dominant group. The combustion of e-wastes led to the most severe contamination of VOCs, with total VOCs (3.3×10(4) μg m(-3)) using rotary incinerators about 190, 180, 139, and 40 times higher than those using mechanical cutting, electric soldering iron, electric blower, and electric heating furnace, respectively. Both cancer and non-cancer risks existed for workers due to exposure to on-site emitted VOCs in all workshops especially in those using rotary incinerators according to the USEPA methodology, whereas only cancer risks existed in rotary incinerator workshops according to the American Conference of Industrial Hygienists methodology.
منابع مشابه
Polychlorinated biphenyls in the atmosphere of Taizhou, a major e-waste dismantling area in China.
PM2.5, total suspended particles (TSP) and gas phase samples were collected at two sites of Taizhou, a major e-waste dismantling area in China. Concentrations, seasonal variations, congener profiles, gas-particle partitioning and size distribution of the atmospheric polychlorinated biphenyls (PCBs) were studied to assess the current state of atmospheric PCBs after the phase out of massive histo...
متن کاملOn-site and off-site atmospheric PBDEs in an electronic dismantling workshop in south China: gas-particle partitioning and human exposure assessment.
Gas samples and total suspended particle during work and off work time were investigated on-site and off-site electronic waste dismantling workshop (I- and O-EWDW), then compared with plastic recycling workshop (PRW) and waste incineration plant (WIP). TSP concentrations and total PBDE were 0.36-2.21 mg/m(3) and 27-2975 ng/m(3) at different workshops, respectively. BDE-47, -99, and -209 were ma...
متن کاملTemporal trends of PCBs, PCDD/Fs and PBDEs in soils from an E-waste dismantling area in East China.
The temporal trends of polychlorinated biphenyls (PCBs), polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) and polybrominated diphenyl ethers (PBDEs) were investigated in soils from an E-waste dismantling area in East China between 2005 and 2011. Isotope dilution high resolution gas chromatography/high resolution mass spectrometry (HRGC/HRMS) was employed for the sample analysis. PC...
متن کاملAssessment and control of VOCs emitted from gas stations in Tehran, Iran
In this research, gasoline vapours including Benzene, Toluene, Xylene (BTX) and Total Volatile Organic Compounds (TVOCs) emitted from vent pipes of underground storage tanks (USTs) were measured at six gas stations in Tehran. Thereafter, gas station No. 29 was selected as a pilot station and equipped with a vapour control system. The vapours were measured during the summer of 2013 and winter of...
متن کاملVoc Emissions from Waste Plastics during Melting Processes
Hazardous compounds emitted during the plastic melting process were analyzed to indicate potential air pollution issues associated with recycle plants for waste plastics. These hazardous compounds might be not only from polymer degradation but also from additives and print ink. To confirm what are emitted from them, melting experiments were conducted (150, 200 and 250°C, in air or N2) and volat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Environment international
دوره 73 شماره
صفحات -
تاریخ انتشار 2014