Design of Microstrip Patch Antenna Array for WLAN Application
نویسندگان
چکیده
In this paper Micro strip Patch Antenna Array are designed and analyzed for WLAN application, which operating at S-band frequency Range of 2.4 GHz. Antenna arrays are used to achieve higher gain. The larger number of antenna elements, the better gain of antenna array is achieved. In this paper feeding element and power divider is used to design the 4 X 1 micro strip patch antenna array. Micro strip line feed and Power divider are used to design parallel Micro strip patch antenna array. The measured radiation pattern and Return loss of 4X1 elements antenna array are presented.
منابع مشابه
Design Investigation of Microstrip Patch and Half-Mode Substrate Integrated Waveguide Cavity Hybrid Antenna Arrays
In this paper two linear arrays including a linear 1×4 and a planar 2×2 of microstrip patch and half-mode substrate integrated waveguide (SIW) cavity hybrid antenna are introduced and investigated. These are simply implemented using low cost single layer printed circuit board (PCB) process. The array element consists of a rectangular microstrip patch with appropriate dimensions in the vicinity ...
متن کاملDesign of a Circularly Polarized Microstrip Antenna for Wlan
The design and performance of a circularly polarized microstrip patch antenna, for the application in Wireless Local Area Network (WLAN), are reported here. The antenna is a proximity coupled microstrip patch antenna where the radiating patch is loaded by a V-slot. This miniaturized microstrip antenna has wide bandwidth in the frequency band of WLAN and exhibits circularly polarized far field w...
متن کاملDesign and Optimization of Multiple slots Microstrip Patch Antenna for WIMAX and WLAN Applications
In this paper, we present multiple L slots antenna for WIMAX and WLAN applications. wideband microstrip patch antenna for wireless applications. The coplanar waveguide fed microstrip patch antenna comprises of four rectangular patch array each embedded on three L slots and a Plus slot either on the patch or on the ground plane or on both the patch and the ground plane. The design results in red...
متن کاملDesign of Single Band Rectangular Patch Antenna for WLAN Application
A microstrip patch antenna for WLAN application is proposed. The antenna has a frequency bandwidth of 196 MHz (5103MHz 5300 MHz). The microstrip antenna has a planar geometry and consists of a ground, a substrate, a patch and a feed. The basic theory and design are analyzed, and simulation using CST Microwave Studio commercial software is employed to optimize the antenna's properties. Results s...
متن کاملA Capacitive Fed Microstrip Patch Antenna with Air Gap for Wideband Applications (RESEARCH NOTE)
In this paper a microstrip antenna on a suspended substrate with capacitive feed is presented. capacitive feed is created by a slot within the rectangular patch around the feed point. The proposed antenna exhibits a much higher impedance bandwidth of about 47% (S11 < −10 dB). Effects of key design parameters such as the air gap between the substrate and the ground plane, the gap width between r...
متن کامل