Investigation of strain-induced martensitic transformation in metastable austenite using nanoindentation
نویسندگان
چکیده
T.-H. Ahn, C.-S. Oh, D.H. Kim, K.H. Oh, H. Bei, E.P. George and H.N. Han* Department of Materials Science and Engineering and Center for Iron and Steel Research, RIAM, Seoul National University, San 56-1, Shinrim-dong, Kwanak-gu, Seoul, 151-744, Republic of Korea Ferrous Alloys Research Group, Korean Institute of Materials Science, 66 Sangnam, Chanwon, 641-831, Republic of Korea Materials Science and Technology Division, Oak Ridge National Laboratory, Oak Ridge, TN 37831, USA
منابع مشابه
Austenite Stability during Nanoindentation of Ultrafine and Coarse Grained AISI 304L Stainless Steels
In the present study, the effect of grain size on the austenite stability was studied by nanoindentation tests in a 304L stainless steel. Thermomechanical processing based on cold rolling and annealing was used to produce two different types of austenite: ultrafine grained (UFG) austenite with the average grain size of 0.65 μm and coarse grained (CG) austenite with the average grain size of 12 ...
متن کاملMicrostructure and Mechanical Properties of Cold Rolled AISI 304L and 316L Austenitic Stainless Steels during Reversion Annealing
Microstructural evolutions during annealing of cold rolled AISI 304L and AISI 316L stainless steels were studied. Cold rolled AISI 304L alloy was fully martensitic but cold rolled AISI 316L alloy was partially martensitic due to the higher stability of the austenite phase in the latter. During continuous heating to elevated temperatures, the complete reversion of strain-induced martensite at 75...
متن کاملEffect of Amorphous Silica Addition on Martensitic Phase Transformation of Zirconia and Investigation of its Tetragonal Structure Stability Mechanisms
This work is focused on the effect of amorphous SiO2 addition on the phase transformation and microstructural evolution of ZrO2 particles. Considering the structural similarities between the amorphous ZrO2 and its tetragonal structure, XRD results showed initial nucleation of metastable tetragonal ZrO2 from its amorphous matrix upon heat treatment. This metastable phase is unstable in pure ZrO2...
متن کاملThermal Stability of Retained Austenite in Bainitic Steel: an in situ study
The tempering of two–phase mixtures of bainitic ferrite and carbon–enriched retained austenite has been investigated in an effort to separate the reactions that occur at elevated temperatures from any transformation during cooling to ambient conditions. It is demonstrated using synchrotron X–radiation measurements, that the residue of austenite left at the tempering temperature partly decompose...
متن کاملThe effect of deep cryogenic treatment on mechanical properties of 80CrMo12 5 tool steel
Cryogenic treatment can be used as a supplemental treatment that is performed on some tool steels between quenching and tempering as an effective method for decreasing retained austenite and increasing wear resistance. In this research, the effect of deep cryogenic treatment (DCT) on dimensional stability and mechanical properties of 80CrMo12 5 tool steel was investigated. The martensitic trans...
متن کامل