Mechanisms of creep deformation in polycrystalline Ni-base disk superalloys
نویسنده
چکیده
Mechanisms of creep deformation in polycrystalline Ni-base disk superalloys R.R. Unocic a,∗, G.B. Viswanathan a, P.M. Sarosi a, S. Karthikeyan b, J. Li a, M.J. Mills a a Department of Materials Science and Engineering, The Ohio State University, 477 Watts Hall, 2041 College Road, Columbus, OH 43210, USA b Department of Materials Engineering, Indian Institute of Science Bangalore, Karnataka 560012, India
منابع مشابه
Deformation Mechanisms in Ni-base Disk Superalloys at Higher Temperatures
This paper presents results from a research initiative aimed at investigating high temperature creep deformation mechanisms in Ni-base superalloys through a combination of creep experiments, TEM deformation mechanism characterization, and state of the art modeling techniques. The effect of microstructure on dictating creep rate controlling deformation mechanisms was revealed for specimens with ...
متن کاملModeling the Temperature-dependence of Tertiary Creep Damage of a Directionally Solidified Ni-base Superalloy
Directionally solidified (DS) Ni-base superalloys have become a commonly used material in gas turbine components. Controlled solidification during the material manufacturing process leads to a special alignment of the grain boundaries within the material. This alignment results in different material properties dependent on the orientation of the material. When used in gas turbine applications t...
متن کاملTemperature and Orientation Dependence of Creep Damage of Two Ni-base Superalloys
Both polycrystalline (PC) and directionally-solidified (DS) Ni-base superalloys are commonly applied as turbine materials to primarily withstand creep conditions manifested in either marine-, airor land-based gas turbines components. The thrust for increased efficiency of these systems, however, translates into the need for these materials to exhibit considerable strength and temperature resist...
متن کاملControlling the Deformation Mechanism in Disk Superalloys at Low and Intermediate Temperatures
The newly developed TMW disk superalloy exhibits better overall mechanical properties in the intended service temperature region (650-750 °C) than the most advanced cast & wrought disk alloy U720Li. Clarification of the underlying mechanisms is beneficial for designing advanced superalloys. Among the TMW alloys, TMW-4M3 has the best tensile strength and creep resistance. In this study, tensile ...
متن کاملSimulation of Creep Crack Growth of a Directionally-solidified Ni-base Superalloy
Creep lifetime of turbine blade material subjected to sustained centrifugal forces at elevated temperatures is limited by accumulated inelastic deformation and creep crack growth (CCG). Creep resistance exhibited in conventionally cast polycrystalline (PC) Ni-base superalloy components has been enhanced via solidification techniques. Directional solidification (DS) results in large grain sizes ...
متن کامل