The trigger mechanism of low-frequency earthquakes on Montserrat
نویسندگان
چکیده
A careful analysis of low-frequency seismic events on Soufrièere Hills volcano, Montserrat, points to a source mechanism that is non-destructive, repetitive, and has a stationary source location. By combining these seismological clues with new field evidence and numerical magma flow modelling, we propose a seismic trigger model which is based on brittle failure of magma in the glass transition. Loss of heat and gas from the magma results in a strong viscosity gradient across a dyke or conduit. This leads to a buildup of shear stress near the conduit wall where magma can rupture in a brittle manner, as field evidence from a rhyolitic dyke demonstrates. This brittle failure provides seismic energy, the majority of which is trapped in the conduit or dyke forming the lowfrequency coda of the observed seismic signal. The trigger source location marks the transition from ductile conduit flow to friction-controlled magma ascent. As the trigger mechanism is governed by the depth-dependent magma parameters, the source location remains fixed at a depth where the conditions allow brittle failure. This is reflected in the fixed seismic source locations. D 2005 Elsevier B.V. All rights reserved.
منابع مشابه
Tolerance Analysis of the Trigger Mechanism Assembly Using Direct Linearization Method
Tolerance analysis of mechanical assemblies is an important tool in reliable design of products at low cost and good quality. Using this tool, it is possible in manufacturing stage to observe the effect of parameters on assembly requirements. The direct linearization method is a useful method which runs based on vector loop analysis. In this research, the DLM method is used to analyze the toler...
متن کاملTolerance Analysis of the Trigger Mechanism Assembly Using Direct Linearization Method
Tolerance analysis of mechanical assemblies is an important tool in reliable design of products at low cost and good quality. Using this tool, it is possible in manufacturing stage to observe the effect of parameters on assembly requirements. The direct linearization method is a useful method which runs based on vector loop analysis. In this research, the DLM method is used to analyze the toler...
متن کاملSiesmic Assessment og Ductility and Strength Capacities of Low-Rise R. C. Buildings
This paper presents a methodology for the assessment of ductility and strength capacities in low-rise buildings. This method utilizes the characteristics of force-displacement for the lowest story level or considers the weakest story in any given low-rise building for its primary analysis. Calculations are based on two levels of earthquake motions, namely strong earthquakes (PGA=0.3 g), and ver...
متن کاملSiesmic Assessment og Ductility and Strength Capacities of Low-Rise R. C. Buildings
This paper presents a methodology for the assessment of ductility and strength capacities in low-rise buildings. This method utilizes the characteristics of force-displacement for the lowest story level or considers the weakest story in any given low-rise building for its primary analysis. Calculations are based on two levels of earthquake motions, namely strong earthquakes (PGA=0.3 g), and ver...
متن کاملSlow earthquakes associated with fault healing on a serpentinized plate interface
Slow earthquakes that occur at subduction zones are distinct from regular earthquakes in terms of their slip behavior. We consider this difference to relate to localized hydration reactions at the plate interface that influence the frictional properties. The results of laboratory friction experiments indicate that simulated serpentine faults are characterized by a low healing rate and large sli...
متن کامل