Sliding Speed-Dependent Tribochemical Wear of Oxide-Free Silicon

نویسندگان

  • Lei Chen
  • Yaqiong Qi
  • Bingjun Yu
  • Linmao Qian
چکیده

Fundamental understanding of tribochemical wear mechanism of oxide-free single crystalline silicon (without native oxide layer) is essential to optimize the process of ultra-precision surface manufacturing. Here, we report sliding speed-dependent nanowear of oxide-free silicon against SiO2 microspheres in air and in deionized water. When contact pressure is too low to induce Si yield, tribochemical wear occurs with the existence of water molecules and wear volume decreases logarithmically to constant as sliding speed increased. TEM and Raman observations indicate that the dynamics of rupture and reformation of interfacial bonding bridges result in the variation of tribochemical wear of the oxide-free Si with the increase of sliding speed.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Tribochemistry and material transfer for the ultrananocrystalline diamond-silicon nitride interface revealed by x-ray photoelectron emission spectromicroscopy

The authors report tribochemical changes due to sliding of a silicon nitride Si3N4 ball against an ultrananocrystalline diamond UNCD thin film. Unidirectional sliding wear measurements were conducted for 2000 cycles using a ball-on-disk apparatus with a 3/16 in. diameter Si3N4 ball at a sliding speed of 3.3 mm/s and a normal load of 98.0 mN nominal Hertzian stress of 0.6 GPa in a nitrogen envir...

متن کامل

Application of Taguchi Technique to Optimize Tribological Behaviour of Al6061T6/SiC/Al2O3 Metal Matrix Composite

Tribological behaviour of aluminium alloy Al6061T6 reinforced with silicon carbide and alumina oxide particles (10%weight percentage of SiC and Al2O3 particles) fabricated by stir casting process was investigated. The wear and frictional properties of the metal matrix composites was studied by performing dry sliding wear test using a computerized pin-on-disc wear tester. Experiments were conduc...

متن کامل

In situ analysis of the tribochemical films formed by SiC sliding against Mo in partial pressures of SO2 , O2, and H2S gases

X-ray photoelectron spectroscopy ~XPS! and Auger electron spectroscopy ~AES! were used to identify gas reaction layers and tribochemical films formed during reciprocating sliding tests in an ultrahigh vacuum ~UHV! tribometer. Tests were performed on UHV cleaned SiC pins and Mo flats during or after exposure to SO2 , O2 , or H2S gas at pressures around 40 Pa. XPS identified the gas reaction laye...

متن کامل

Effect of crystal plane orientation on tribochemical removal of monocrystalline silicon

The effect of crystal plane orientation on tribochemical removal of monocrystalline silicon was investigated using an atomic force microscope. Experimental results indicated that the tribochemical removal of silicon by SiO2 microsphere presented strong crystallography-induced anisotropy. Further analysis suggested that such anisotropic tribochemical removal of silicon was not dependent on the c...

متن کامل

Influence of Sliding Speed on Tribological Behavior of Hypereutectic Al-15si-4cu Cast Alloy with Melt Treatments

Hypereutectic aluminum silicon alloys are mainly used in cast form in important components like pistons, cylinder liners, rocker arms, air conditioner compressors, brake drums, engine blocks, etc. These have inherent advantages of being high wear resistance, high strength to weight ratio, high corrosion resistance, good cast performance, high thermal conductivity, good weldability, etc. The inf...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 12  شماره 

صفحات  -

تاریخ انتشار 2017