Mechanical stability and reversible fracture of vault particles.

Thermal Stability and Dynamic Mechanical Properties of Nano and Micron-TiO2 Particles Reinforced Epoxy Composites: Effect of Mixing Method

New Insight on Deformation of Walnut/Ceramic Proppant Pack under Closure Stress in Hydraulic Fracture: Numerical Investigation

This study is an attempt to investigate the mechanical behavior of proppant packs deforming under compression loading. A generalized confined compression test (CCT) was simulated in the present study to investigate the deformation of walnut/ceramic proppants against compression. In this way, the CCT was simulated using ABAQUS explicit code. Unlike ordinary CCT, we obtained permeability of compr...

Effect of the Particle Size on the Deformation and Fracture Behavior of Al/4vol.%Al2O3 Composite Produced by Accumulative Roll Bonding (ARB)

In this study, Al/Al2O3 composites with two different particle sizes of 1 µm and 0.3 µm were produced via accumulative roll bonding (ARB). The microstructure evolution, mechanical properties and fracture behavior of the composites were investigated. Results show that higher ARB cycles are required to achieve a uniform distribution of particles in the composite with 0.3 µm particle size. During ...

Temperature Effect on Creep and Fracture Behaviors of Nano-SiO2-composite and AlSi12Cu3Ni2MgFe Aluminum Alloy

In the presented article, the temperature effect was studied on creep properties and fracture behaviors of AlSi12Cu3Ni2MgFe aluminum-silicon alloys, unreinforced and reinforced with SiO2 nano-particles. For such objective, standard specimens were fabricated by gravity casting and stir-casting methods, for aluminum alloys and nano-composites, respectively. Then, force-controlled creep...

MECHANICAL PROPERTIES OF DENTAL COMPOSITE MATERIALS REINFORCED WITH MICRO AND NANO-SIZE Al2O3 FILLER PARTICLES

Abstract: Composite specimens were prepared by dispersion of various amounts of nano-sized Al2O3 fillers in a monomer system containing 60% Bis-GMA and 40% TEGDMA. For comparative purposes, composite samples containing micrometer size Al2O3 fillers were also prepared following the same procedure. The mechanical properties of the light- cured samples were assessed by three-point flexural strengt...