A Combined Optical, Thermal and Electrical Performance Study of a V-Trough PV System—Experimental and Analytical Investigations
نویسندگان
چکیده
The objective of this study was to achieve higher efficiency of a PV system while reducing of the cost of energy generation. Concentration photovoltaics was employed in the present case as it uses low cost reflectors to enhance the efficiency of the PV system and simultaneously reduces the cost of electricity generation. For this purpose a V-trough integrated with the PV system was employed for low concentration photovoltaic (LCPV). Since the electrical output of the concentrating PV system is significantly affected by the temperature of the PV cells, the motivation of the research also included studying the ability to actively cool PV cells to achieve the maximum benefit. The optical, thermal and electrical performance of the V-trough PV system was theoretically modeled and validated with experimental results. Optical modeling of V-trough was carried out to estimate the amount of enhanced absorbed radiation. Due to increase in the absorbed radiation the module temperature was also increased which was predicted by thermal model. Active cooling techniques were studied and the effect of cooling was analyzed on the performance of V-trough PV system. With absorbed radiation and module temperature as input parameters, electrical modeling was carried out and the maximum power was estimated. For the V-trough OPEN ACCESS Energies 2015, 8 2804 PV system, experiments were performed for validating the numerical models and very good agreement was found between the two.
منابع مشابه
Experimental investigation of thermal and electrical performances of a nanofluid-cooled photovoltaic/thermal system equipped with a sheet-and-grooved serpentine tube collector
Introduction: In the present experimental investigation, the thermal and electrical performances of a photovoltaic/thermal system equipped with a sheet-and-grooved serpentine tube collector are investigated. The water-magnetite nanofluid is used as the heat transfer fluid. The effect of nanoparticle volume concentration (0-1%), nanofluid mass flow rate (10-40 kg/h) and groove pitch (0, 0.54 an...
متن کاملThe effect of SiO2 nanoparticle on the performance of photovoltaic thermal system: Experimental and Theoretical approach
The low conversion efficiency of solar cells produces large amounts of thermal energy to the cells, and with an increase in the temperature of solar cells, their electrical efficiency decreases. Therefore, a hybrid photovoltaic thermal system improves the overall efficiency of the system by adding thermal equipment to the solar cell and removing excessive heat from these cells. In this paper, w...
متن کاملThermodynamic diagnosis of a novel solar-biomass based multi-generation system including potable water and hydrogen production
In this study, a new proposed multi-generation system as a promising integrated energy conversion system is studied, and its performance is investigated thermodynamically. The system equipped with parabolic trough collectors and biomass combustor to generate electricity, heating and cooling loads, hydrogen and potable water. A double effect absorption chiller to provide cooling demand, a proton...
متن کاملEnergy and Exergy Analysis of Air PV/T Collector of Forced Convection with and without Glass Cover
In this study, the overall performance of air PV/T, based on energy and exergy analysis has been investigated. Two combinations of air PV/T, which consist of unglazed and glazed air PV/T, are considered. Thermal analysis and numerical calculations were carried out, and the performance parameters of the system for the climate conditions of Kerman were studied. The results are presented in graphs...
متن کاملHeat Response Model for Phase Layered Topology in a Photovoltaic Thermal System
The electrical and thermal energy generated by a Photo-voltaic (PV) module is based on the amount of the solar radiation directed on the PV module. In this study, a Photo-voltaic Thermal (PVT) system is constructed to maximize the electrical energy generation through the fast removal of heat through a new phase layered topology. The combinations of aluminum plate and heatsinks are used to trans...
متن کامل