Modulation of intracellular Na+ and Ca2+ induced by the cardiac Na+-Ca2+ exchanger in guinea pig ventricular myocytes.

The Na+-Ca2+ exchanger current was measured in single guinea pig ventricular myocytes, using the whole-cell voltage-clamp technique, and intracellular free calcium concentration ([Ca2+](i)) was monitored simultaneously with the fluorescent probe Indo-1 applied intracellularly through a perfused patch pipette. In external solutions, which have levels of Ca2+ (approximately 66 microM Ca2+) thought low enough to inhibit exchanger turnover, the removal of external Na+ (by replacement with Li+) induced both an outward shift of the holding current and an increase in [Ca2+](i), even though the recording pipette contained 30 mM bis(O-aminophenoxy)ethane-N,N,N',N'-tetraacetic acid (BAPTA), sufficient to completely block phasic contractions. The effects of Na+ removal were blocked either by the extracellular application of 2 mM Ni2+ or by chelating extracellular Ca2+ with 1 mM EGTA. In the presence of 10 microM Ryanodine, the effects of external Na+ substitution with Li(+) on both membrane current and [Ca2+](i) were attenuated markedly in amplitude and at a much slower time course. Reversal potentials were estimated by using ramp pulses and by defining exchange currents as the Ni2+-sensitive components. The experimental values of the reversal potential and [Ca2+](i) were used to calculate cytosolic Na+ ([Na+](i)) by assuming an exchanger stoichiometry of 3Na+ : 1Ca2+. These calculations suggested that in the nominal absence of external Ca2+ ( approximately 66 microM under our experimental conditions), the exchanger operates at -40 mV as though approximately 40 mM Na+ had accumulated in the vicinity of the intracellular binding sites. We conclude that under the conditions of low extracellular Ca2+ and high intracellular Ca2+ buffering, the Na+-Ca2+ exchanger can still generate sufficient Ca2+ influx on the removal of external Na+ to markedly increase cytosolic free Ca2+.