Phase Changes of Monosulfoaluminate in NaCl Aqueous Solution
نویسندگان
چکیده
Monosulfoaluminate (Ca₄Al₂(SO₄)(OH)12∙6H₂O) plays an important role in anion binding in Portland cement by exchanging its original interlayer ions (SO₄2- and OH-) with chloride ions. In this study, scanning transmission X-ray microscope (STXM), X-ray absorption near edge structure (XANES) spectroscopy, and X-ray diffraction (XRD) were used to investigate the phase change of monosulfoaluminate due to its interaction with chloride ions. Pure monosulfoaluminate was synthesized and its powder samples were suspended in 0, 0.1, 1, 3, and 5 M NaCl solutions for seven days. At low chloride concentrations, a partial dissolution of monosulfoaluminate formed ettringite, while, with increasing chloride content, the dissolution process was suppressed. As the NaCl concentration increased, the dominant mechanism of the phase change became ion exchange, resulting in direct phase transformation from monosulfoaluminate to Kuzel's salt or Friedel's salt. The phase assemblages of the NaCl-reacted samples were explored using thermodynamic calculations and least-square linear combination (LC) fitting of measured XANES spectra. A comprehensive description of the phase change and its dominant mechanism are discussed.
منابع مشابه
The experimental study of reverse micellar phase in AOT/ Heptane/ (Water or aqueous) as nano template
In this paper electrical conductivity measurements and optical investigations takes place in AOT/ heptane/ (water or aqueous) systems. The water in oil system prepared with adding water in 50% by weight of AOT/ heptane solution. In other systems instead of water, aqueous solutions of 1) zinc acetate and water 2) Potassium Hydroxide and water were used. In each phase, the trend of the electrica...
متن کاملThe experimental study of reverse micellar phase in AOT/ Heptane/ (Water or aqueous) as nano template
In this paper electrical conductivity measurements and optical investigations takes place in AOT/ heptane/ (water or aqueous) systems. The water in oil system prepared with adding water in 50% by weight of AOT/ heptane solution. In other systems instead of water, aqueous solutions of 1) zinc acetate and water 2) Potassium Hydroxide and water were used. In each phase, the trend of the electrica...
متن کاملInvestigation of the effect of different parameters on the phase inversion temperature O/W nanoemulsions
Objective(s): Nanoemulsions are a kind of emulsions that can be transparent, translucent (size range 50-200 nm) or “milky” (up to 500 nm). Nanoemulsions are adequatly effective for transfer of active component through skin which facilitate the entrance of the active component . The transparent nature of the system and lack of the thickener and fluidity are among advantages of nanoemulsion. Mate...
متن کاملExtraction of Acetaminophen from Aqueous Solution by Emulsion Liquid Membrane Using Taylor-Couette Column
A study on the extraction of Acetaminophen (ACTP) which is also known as paracetamol, from aqueous solution by emulsion liquid membrane process using Taylor-Couette Column (TCC) was investigated. An ELM consists of three phase system which are the external, membrane and internal phases. The external phase containing the ACTP aqueous solution to be treated. Basically, the internal and membrane p...
متن کاملAdsorption Behavior of MWAR Toward Gd(III) in Aqueous Solution
Adsorption and desorption behavior of Gd(III) ionon macroporous weak acid resin (MWAR) had been investigated.The influence of operational conditions such as contact time, initial concentration of Gd(III) ion, initial pH of solution and temperature on the adsorption of Gd(III) ion had been examined. Experimental data were exploited for kinetic and thermodynamic evaluations ...
متن کامل