Modelling of the Francis turbine runner in power stations. Part II: stress analysis
نویسندگان
چکیده
The second part of this paper presents results of stress analysis of the whole Francis turbine runner at Derbendikan power station by using the Finite Element Method (FEM). Computations were carried out with appropriate boundary and loading conditions for water pressure obtained from CFD analysis. The analysis focuses on stress distribution in the runner blades. It has been found that the maximum stresses due to the water pressure are located at the trailing edge of the runner blade towards the transition between the blade and the crown. This explains why this region has been identified as a critical area for fatigue crack initiation in the Francis turbine runner.
منابع مشابه
Numerical Study of a Pipe Extension Effect in Draft Tube on Hydraulic Turbine Performance
Draft tube of Francis type hydraulic turbine usually consists of: cone, elbow and diffuser. On the contrary, in some power stations an extra pipe should be added to the draft tube at the bottom of cone because of installation limitation. In this paper, this special case has been numerically studied. To this end CFD analysis was applied to simulate all parts of hydraulic turbine. A homogeneous m...
متن کاملComplete Francis turbine flow simulation at Derbendikan power station
This paper presents the results of simulations of the complete three-dimensional fluid flow through the Spiral Casing, Stay Vane, Guide Vane, and then through the Francis turbine runner of the Derbendikan power station. To investigate the flow in the Francis turbine and also to identify the loads acting on the turbine blades, a three-dimensional model was prepared according to specifications pr...
متن کاملInvestigation of a High Head Francis Turbine at Runaway Operating Conditions
Hydraulic turbines exhibit total load rejection during operation because of high fluctuations in the grid parameters. The generator reaches no-load instantly. Consequently, the turbine runner accelerates to high speed, runaway speed, in seconds. Under common conditions, stable runaway is only reached if after a load rejection, the control and protection mechanisms both fail and the guide vanes ...
متن کاملOptimization of GAMM Francis Turbine Runner
Nowadays, the challenge in hydraulic turbine design is the multi-objective design of turbine runner to reach higher efficiency. The hydraulic performance of a turbine is strictly depends on runner blades shape. The present paper focuses on the application of the multi-objective optimization algorithm to the design of a small Francis turbine runner. The optimization exercise focuses on the effic...
متن کاملModelling and Simulation of Low-Head Hydro Turbine for Small Signal Stability Analysis in Power System
The hydro turbine dynamics have a considerable influence on the dynamic stability of power system. In the study of dynamic stability, the system is modeled by the linear differential equations (small signal analysis). Small signal stability of power systems is needed in all conditions and only is dependent on the conditions of power system performance before commotion occurrence. This paper pr...
متن کامل