Nonl inear Dis turbance Reject ion for Magnet ic
نویسنده
چکیده
1 I n t r o d u c t i o n With ever increasing demands placed on precision and reliability within manufacturing and research environments, magnetic levitation systems are finding increased utilization within such applications as machine tooling due to their non-contact (i .e. , low friction) force exertion and their capability for active at tenuation of mechanical vibrations. However, magnetic levitation systems suffer from various control complexities such as: i.) open-loop instability, ii.) inherent nonlinearities within the system model, iii.) a unidirectional force input, and iv.) continuous biasing. In response to these difficulties, researchers have employed various modelling and control development techniques to address the aspects of i.) through iii.). For example, Charara et al. [2] constructed a nonlinear model of an inertial wheel supported by active magnetic bearings, for which a sliding mode controller was then designed to stabilize the system. In [7], L@vine et al. proposed a nonlinear feedback control law for the positioning of a shaft based on the current complementarity or current almost complementarity condition. Queiroz et al. [4] utilized a nonlinear model of a planar rotor disk, active magnetic bearing system to develop a global exponential position tracking controller for the full-order electromechanical system. In [8], Mohamed et al. demonstrated that the Q-parameterization theory could be utilized to autobalance the rotor of a vertical shaft active magnetic bearing system. Recently, much effort has been directed toward the area of disturbance suppression within magnetic levitation sys1This work is supported in part by the U.S. NSF Grants DMI9457967, ONR Grant N00014-99-1-0589, a DOC Grant, and an ARO Automotive Center Grant. tems. For example, in [3], Costic et al. introduced a learning based controller to asymptotically regulate a magnetic bearing system while compensating for periodic, exogenous disturbances. Rodrigues et al. [9] proposed an interconnection and damping assignment Passivity-Based controller to yield a smooth stabilizing controller for the active magnetic bearing system. In [6], Gentili utilized a model-based regulation approach to achieve set point regulation of the target with the disturbance input being modeled as the sum of a finite number of sinusoids. Similarly, Behal et al. [1] designed a set of linear, bounded-input bounded-output filters to facilitate the utilization of s tandard adaptive techniques that compensated for an unknown sinusoidal disturbance signal. Though not directly targeted at magnetic levitation systems, Xian et al. [11] proposed an adaptive disturbance rejection approach for single-input single-output, linear time invariant, uncertain systems subjected to sinusoidal disturbances with unknown amplitude and frequency. The approach of [11] utilizes a state estimate observer in a back stepping fashion with only output measurements to achieve asymptotic disturbance rejection. In this paper, the topic of disturbance rejection within the magnetic levitation area is furthered pursued by designing a saturated force control input that achieves asymptotic target position regulation despite the presence of a nonl inear, bounded, periodic disturbance. The control development differs from previous disturbance rejection controllers in that restrictions on the explicit s tructure of the disturbance signal are not required (i .e. , the disturbance force need only be bounded and periodic). As with previously designed magnetic levitation controllers, the proposed control structure must contend with the constraint that the actuation force is unidirectional. That is, the magnetic actuator can only exert an attractive force on the target mass (the earth 's gravitational field is utilized to produce the repulsive action). The remainder of the paper is organized as follows. The model of a magnetic levitation system actuating on a target mass suspended in the gravitation field is presented in Section II. Section III identifies the control objectives and constraints of the control development. The saturated control force input and the learning based disturbance estimator are presented in Section IV. A Lyapunov stability analysis is utilized to illustrate the asymptotic regulation of the target position. Simulation results are presented in Section V. 0-7803-7891-1/03/$17.00 © 2003 IEEE 58 Report Documentation Page Form Approved OMB No. 0704-0188 Public reporting burden for the collection of information is estimated to average 1 hour per response, including the time for reviewing instructions, searching existing data sources, gathering and maintaining the data needed, and completing and reviewing the collection of information. Send comments regarding this burden estimate or any other aspect of this collection of information, including suggestions for reducing this burden, to Washington Headquarters Services, Directorate for Information Operations and Reports, 1215 Jefferson Davis Highway, Suite 1204, Arlington VA 22202-4302. Respondents should be aware that notwithstanding any other provision of law, no person shall be subject to a penalty for failing to comply with a collection of information if it does not display a currently valid OMB control number. 1. REPORT DATE 2003 2. REPORT TYPE 3. DATES COVERED 00-00-2003 to 00-00-2003 4. TITLE AND SUBTITLE Nonlinear Disturbance Rejection for Magnetic Levitation Systems 5a. CONTRACT NUMBER
منابع مشابه
Propa Ga T Io N of T E Wav Es in Nonli Nea R Wav Eg Ui De
Propagation in l inear planar wa vegui des is a wel l-known pro blem , whereas pro pagati on in nonl inear waveguides wa s considered onl y in parti cular cases. Tha t is the caseof the nonl inear waveguide wi th a l inear Ùlm on a nonl inear substra te [1], then the l inear Ùlm surro unded by the nonl inear substra te and cover [2{ 7], the nonl inear Ùlm surro unded by l inear isotro pi c m ed...
متن کاملOptimal Control Prob lem for Nonl inear Stochast ic Difference Second Kind Volterra Equations
متن کامل
Nonl inear Dis turbance Reject ion for Magnet ic Levitat ion
1 I n t r o d u c t i o n With ever increasing demands placed on precision and reliability within manufacturing and research environments, magnetic levitation systems are finding increased utilization within such applications as machine tooling due to their non-contact (i .e. , low friction) force exertion and their capability for active at tenuation of mechanical vibrations. However, magnetic ...
متن کاملNew Codes with the Same Weight Distributions as the Goethals Codes and the Delsarte-Goethals Codes - Information Theory, 1995. Proceedings., 1995 IEEE International Symposium on
The Goetha ls code is a b inary nonl inear code of length 2""" which has 22m+1-3m-2 codewords and m i n i m u m H a m m i n g dis tance 8 for a n y odd m 2 3. We cons t ruc t n e w codes over 2 4 such that their G r a y maps lead to codes w i t h the same weight dis t r ibut ion as the Goetha ls codes and the Delsar te-Goethals codes.
متن کاملA Class of Low-Rate Nonlinear Binary Codes
T h i s paper in t roduces a new class of nonl inear b inary codes. For each l = 2, 3,... we presen t a code wi th 2 4z codewords of l eng th N = 4 z and dis tance d ~ (4 z U)]2. Each code is a supercode of the l s t -o rde r R e e d M u l l e r (RM) code and a subcode of the 2nd-order R M code. T h e s e codes are the "dua l s " of the ex tended nonl inear Preparata codes in the sense tha t th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2008