Pii: S0032-3861(00)00149-x

The effect of moisture content and temperature on the melt ̄ow behavior and the resulting morphology of thermoplastic starch (TPS)/ poly(hydroxy ester ether) blends is studied. The viscosity ratio (l) was found to vary over two orders of magnitude (0.1±10) with changes in the TPS moisture content (15±30%) and temperature (120±1608C). This had a substantial effect on the level of mixing, nature of dispersion and the onset and nature of co-continuity. Deformation (in the ̄ow direction) of the dispersed starch phase was possible under high moisture conditions (higher l), leading to ®brillar and laminar types of morphologies at 50±80% starch level, whereas processing at a low moisture level (lower l) produced a more dispersed morphology. When the viscosities of the two phases were signi®cantly different, the low-viscosity polymer migrated to the surface. Surprisingly l increased with temperature at 20% moisture TPS but decreased with temperature at 30% moisture TPS. Hence, moisture content and temperature greatly affected the surface enrichment of the lower viscosity polymer. Water partitioning took place between TPS and PHEE during extrusion, dependent on the pre-extrusion moisture content of TPS but independent of the relative concentrations of the two polymers. q 2000 Published by Elsevier Science Ltd. All rights reserved.