Cycloidal Cyclical Surfaces
نویسنده
چکیده
The paper presents a family of cycloidal cyclical surfaces, which are created by a movement of a circle alongside the special spatial cycloidal curve, where the circle is located in the curve normal plane and its centre is on this curve. The spatial cycloidal curve can be created by simultaneous revolution of a point about three different axes 3o,2 o and 1o in the space. The form of the cycloidal curve and also of the cycloidal cyclical surface depends on the relative position of the three axes of revolutions, on multiples of angular velocities and orientations of separate revolutions. The analytic representation, the classification of surfaces and some of their geometric properties are derived.
منابع مشابه
Kinematical and Dynamic Aspects of a Cycloidal Planetary Reducer with Modified Structure
The paper deals with some representative geometrical and dynamic aspects of a new cycloidal reducer variant with modified structure, proposed by the authors: geometrical optimization of the cycloidal gear, analysis of the transmission ratio and efficiency, and analysis of the dynamic response in a relevant functioning case.
متن کاملCyclical Surfaces Created by a Conical Helix
The paper describes cyclical surfaces created by revolution of a circle about an edge of the trihedron of a conical helix that is moving evenly along the helix. This Euclidean metric transformation is composed from revolution about one of the coordinate axes and transformation of the righthanded coordinate system to the right-handed system of the moving trihedron in every point of the conical h...
متن کاملLimits to Control of Ship Capsize Using Cycloidal Propellers Compared to Active Fins
A non-linear mathematical model, for the roll-yaw behaviour of a ship, is used to predict the prevention of capsize of a small ship. The problem was simulated using the digital package SIMULINK. Simulated responses of the ship with simple hydrodynamic fin stabilisers show that capsize could have been prevented by this means in waves up to 7 m in height. Active control using a simple full span c...
متن کاملGeometry Design and Analysis for Trochoidal·type Speed Reducers: with Conjugate Envelopes
This paper illustrates the use of the envelope theorem for the geometric design of a cycloidal speed reducer. Specifically, it proposes two designs for a mathematical model with tooth differences: a pin wheel epitrochoid meshing which is a cycloidal wheel (internal rotor) profile equidistant to an epitrochoid (or extended epicycloid) curve and a cycloida! wheel is generated by a pin wheel (exte...
متن کاملNew Insight into Cycloidal Areas
1. INTRODUCTION. A cycloid is the path traced by a point on the boundary of a circular disk that rolls without slipping along a straight line. It forms a sequence of arches resting on the line, as shown in Figure 1. It is known that the area of the shaded region below one arch is three times the area of the rolling disk. Our analysis shows that the factor 3 reflects a much deeper property of cy...
متن کامل