Effects of 6 self-etching primers on shear bond strength of orthodontic brackets.

نویسندگان

  • Rogelio J Scougall-Vilchis
  • Shizue Ohashi
  • Kohji Yamamoto
چکیده

INTRODUCTION This study was conducted to compare the effects of 6 self-etching primers (SEPs) on the shear bond strength (SBS) of orthodontic brackets bonded with the same orthodontic composite resin. METHODS One hundred forty extracted premolars were randomly divided into 7 groups (20 per group). In group I (control), the enamel was etched with 37% phosphoric acid. In the other groups, it was conditioned with SEPs according to each manufacturer's instructions: group II, Transbond Plus SEP (3M Unitek, Monrovia, Calif); group III, AdheSE (Ivoclar Vivadent AG, Schaan, Liechtenstein); group IV, Primers A and B (Shofu, Kyoto, Japan); group V, Clearfil Mega Bond FA (Kuraray Medical, Tokyo, Japan); group VI, Peak SE and Peak LC Bond (Ultradent Products, South Jordan, Utah); and group VII, Bond Force (Tokuyama, Osaka, Japan). All brackets were bonded with Transbond XT (3M Unitek), and the teeth were then stored (37 degrees C, 24 hours), tested, and statistically analyzed (Scheffé, ANOVA [P <0.05], and Weibull analyses). The adhesive remnant index (ARI) was also recorded. RESULTS Group I (26.5 +/- 8.1 MPa) had a significantly higher SBS value than the other groups except group II (21.1 +/- 6.2 MPa). There were no significant differences among groups II, V (19.0 +/- 4.3 MPa), VI (19.6 +/- 5.1 MPa), and VII (18.3 +/- 4.4 MPa). The values for groups I, II, and VI were significantly higher than for group III (13.4 +/- 4.1 MPa), and the value for group IV (8.8 +/- 2.6 MPa) was significantly lower than the values for groups I, II, V, VI, and VII. Significant differences were found in the ARI scores. CONCLUSIONS The SBS values of all groups might be clinically acceptable, and orthodontic brackets can be successfully bonded with Transbond XT after enamel conditioning with any of these SEPs. However, since the SEPs used in groups III and IV significantly affected the bond strength negatively, further studies are warranted to evaluate their effectiveness.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effect of Saliva Contamination and sequencing time of curing the Transbond™ Plus Self Etching Primer on the Shear Bond Strength of Orthodontic Brackets

Abstract Background and aim: Over the years, improvments have been done to simplify clinical bonding procedure. One of these material is Transbond™ Plus Self Etching. The aim of this study was to evaluate the effect of saliva contamination and reusing Transbond™ Plus Self Etching Primer (SEP) on shear bond strength of orthodontic brackets. Materials and Methods: Fifty premolars divided into fiv...

متن کامل

Comparison of shear bond strength of the stainless steel metallic brackets bonded by three bonding systems

Introduction: In orthodontic treatment, it is essential to establish a satisfactory bond between enamel and bracket. After the self-etch primers (SEPs) were introduced for the facilitation of bracket bonding in comparison to the conventional etch-and-bond system, multiple studies have been carried out on their shear bond strengths which have yielded different results. This study was aimed at co...

متن کامل

In vitro Effects of a Neutral Fluoride Agent on Shear Bond Strength and Microleakage of Orthodontic Brackets

Introduction: This study aimed to evaluate the effect of pretreatment with a neutral fluoride agent on shear bond strength (SBS) and microleakage of orthodontic brackets, and to investigate any significant relationship between SBS and microleakage. Methods: Forty intact premolars were selected and randomly divided into 2 groups. Group 1 served as the control, while group 2 underwent treatment w...

متن کامل

تأثیر روشهای آماده کردن سطح مینا بر استحکام باند براکت ارتودنسی

Background and Aim: With the introduction of different bondable restorative materials in dentistry, various methods have been suggested to enhance the polymerization and shear bond strength of these materials. The aim of this study was to determine the effects of different methods of enamel conditioning on bond strength of orthodontic brackets and on the bracket/ adhesive failure mode. Material...

متن کامل

Comparison between self-etching and conventional primers in repeated bracket bonding

Background and Aim: This study aimed to evaluate the effect of repeated bonding by self-etching primers (SEPs) and a conventional phosphoric acid-etchant on shear bond strength (SBS), adhesive remnant index (ARI), and enamel morphology at different debonding time points. Materials and Methods: In this experimental study, 120 premolars were randomly divided into six groups of 20. In the first t...

متن کامل

Effect of Pretreatment with Fluoride, Chlorhexidine, and Mixed Fluoride-Chlorhexidine Gels on Shear Bond Strength of Orthodontic Brackets: An Ex-Vivo Study

Background and Aim: Orthodontic patients are at an increased risk of caries due to difficulty in plaque control. Antimicrobial agents, such as fluoride and chlorhexidine, can be useful in preventing tooth demineralization. The present study aimed to determine the effect of fluoride and chlorhexidine gels and their mixture on the shear bond strength (SBS) of orthodontic brackets. Materials and ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • American journal of orthodontics and dentofacial orthopedics : official publication of the American Association of Orthodontists, its constituent societies, and the American Board of Orthodontics

دوره 135 4  شماره 

صفحات  -

تاریخ انتشار 2009