Low-Power Switched Current Memory Cell with CMOS-Type Configuration
نویسندگان
چکیده
SUMMARY This letter presents a low-power switched current (SI) memory cell with CMOS-type configuration. By combining nMOS and pMOS in the SI memory cell and using a polarity discrimination circuit, we design a CMOS-type SI memory cell which eliminates the quiescent current in the SI memory cell. The simulation result shows that the CMOS-type SI memory cell consumes less power than the conventional class-AB memory cell.
منابع مشابه
Analysis and Design of High Gain, and Low Power CMOS Distributed Amplifier Utilizing a Novel Gain-cell Based on Combining Inductively Peaking and Regulated Cascode Concepts
In this study an ultra-broad band, low-power, and high-gain CMOS Distributed Amplifier (CMOS-DA) utilizing a new gain-cell based on the inductively peaking cascaded structure is presented. It is created bycascading of inductively coupled common-source (CS) stage and Regulated Cascode Configuration (RGC).The proposed three-stage DA is simulated in 0.13 μm CMOS process. It achieves flat and high ...
متن کاملAnalysis and design of a CMOS current reused cascaded distributed amplifier with optimum noise performance
In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...
متن کاملDesign of a Low Power Magnetic Memory in the Presence of Process Variations
With the advancement in technology and shrinkage of transistor sizes, especially in technologies below 90 nm, one of the biggest problems of the conventional CMOS circuits is the high static power consumption due to increased leakage current. Spintronic devices, like magnetic tunnel junction (MTJ), thanks to their low power consumption, non-volatility, compatibility with CMOS transistors, and t...
متن کاملA Low-Voltage, Low-Power, Two-Stage Amplifier for Switched-Capacitor Applications in 90 nm CMOS Process
Abstract- A novel low-voltage two-stage operational amplifier employing resistive biasing is presented. This amplifier implements neutralization and correction common mode stability in second stage while employs capacitive dc level shifter and coupling between two stages. The structure reduces the power consumption and increases output voltage swing. The compensation is performed by simple mill...
متن کاملSwitched-Current Cells in Standard CMOS Process
The minimum supply voltage €or a typical switched-current (SI) cell can be shown to be greater than 2 v ~ + 2VDssat approximately due to the fact that an additional voltage drop is required for the MOS switch, which is connected to the gate of the memory transistor. Thus, a minimum supply voltage of 1.5 V is usually required in a standard CMOS process. In this paper, an active switching scheme ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- IEICE Transactions
دوره 91-C شماره
صفحات -
تاریخ انتشار 2008