Model-based cold-start speed control scheme for spark ignition engines
نویسندگان
چکیده
This paper presents a model-based control scheme to the cold-start speed control in spark ignition (SI) engines. The multi-variable control algorithm is developed with the purpose of improving the transient performance of the starting engine speed: the control inputs are the fuel injection, the throttle and the spark advance (SA), while the engine speed and the air mass flow rate are the measured signals. The fuel injection is performed with a dual sampling rate system: the cycle-based fuel injection command is individually adjusted for each cylinder by using a TDC (top dead center)-based air charge estimation. The desired performance for speed regulation is achieved by using a coordinated control of SA and throttle operation. The speed error convergence of the closed loop system is proved for simplified, second-order model with a time-delay, and the robustness with respect to parameter uncertainties is investigated. The performance and the robustness with respect to modeling uncertainties of the proposed control scheme are tested using an industrial engine simulator with six cylinders. & 2010 Elsevier Ltd. All rights reserved.
منابع مشابه
Model-based Cold-start Speed Control Design for SI Engines
This paper presents a feedback deign approach to the cold-start speed control for spark ignition engines. First, in order to ensure successful combustion in the transient mode, a fuel injection controller is given based on the air charge estimation with inverse dynamics of fuel path, which is a dual sampling rate system, i.e. the estimation for the air charge is performed TDC-based, and the fue...
متن کاملOptimal cold start calibration of spark ignition engines
This paper investigates optimal strategies for minimising the conflicting objectives of fuel consumption and warm up duration following an engine cold start. Using a reduced order model, parametric solutions for the optimal air-fuel ratio, valve timing, cam timing and idle speed setpoint are sought in the presence of input constraints. The results are then validated using a dynamic programming ...
متن کاملProviding a thermodynamic model to simulate the spark ignition engine fueled with natural gas and ethanol mixture
The use of natural gas as an alternative fuel, in recent decades has been proposed. Good combustion properties and cats less than it could be the perfect choice for the next generation. Simulation models can be of great help engine designers. Simulation models to reduce the time and costs for the development of new engines as well as in identifying the technical value that need special attentio...
متن کاملExperimental investigations on a pre-chamber spark plug with variable heat range by integrating a controlled hot surface
In gasoline engines, pre-chamber spark ignition systems are used to achieve high efficiency and low NOx emissions when operating under lean conditions. While a cold pre-chamber spark plug can lead to misfiring and flame quenching under cold start or part load operation, a hot pre-chamber can result in uncontrolled pre-ignition phenomena under full load operation. This paper presents an approach...
متن کاملStarting Speed Control of SI Engine Based on Extremum Seeking Control
The extremum seeking controller (ESC) that minimizes the unknown performance index is applied to the control of SI (spark ignition) engines in the idle speed region. The proposed control system consists in the three parts, fuel-jet mount controller, ignition-timing controller and engine speed controller. The ESC applied to the engine speed controller should be modified in order to improve the e...
متن کامل