AbstractID: 14214 Title: A novel scatter reduction and correction method to improve cone-beam CT (CBCT) image quality

ثبت نشده
چکیده

ID: 14214 Title: A novel scatter reduction and correction method to improve cone-beam CT (CBCT) image quality Purpose: To develop a novel scatter reduction and correction method to improve the CBCT image quality for IGRT applications. Method and Materials: A one-dimensional grid composed of lead with equal interspacing was positioned between the x-ray source and the imaging object during CBCT acquisition. The grid provides direct scatter reduction by blocking half of the beams. Partial image data were obtained from the grid inter-space (unblocked) region while scatter was measured from the blocked region beneath the grid in the projection images. Scatter was corrected by subtracting the measured scatter from the original projection image. Information in the penumbra region of each grid septa was derived. Three modes were developed to reconstruct full CBCT images from partially blocked projections. In single rotation axial mode, interpolation was used to fill in the missing data in the half-fan projections. In dual rotation mode, two-rotation half-fan scans were acquired with the grid offset by half a grid cycle, and complimentary projections were merged to form complete projections for reconstruction. In single rotation helical mode, one-rotation full-fan scan was acquired with the grid offset by half a grid cycle at the scan center. Both CatPhan and anthropomorphic pelvis phantoms were used to evaluate the method. Results: In the CatPhan study, CNR was improved using our approach from 4.3 to 6.4 in comparison to conventional CBCT, and CT-number linearity correlation coefficient increased from 0.88 to 0.998. Scatter induced streak artifacts were significantly reduced. In the pelvis phantom study, complete sets of CBCT images were reconstructed and scatter related artifacts were significantly reduced in all three modes. Conclusion: Our method enhances CNR and provides much more accurate measurement of scatter with reduced or equivalent dose to conventional CBCT. Scatter-related artifacts are substantially reduced, and the CBCT images generated are of appropriate quality for adaptive radiation therapy.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Artifact reduction techniques in Cone Beam Computed Tomography (CBCT) imaging modality

Introduction: Cone beam computed tomography (CBCT) was introduced and became more common based on its low cost, fast image procedure rate and low radiation dose compared to CT. This imaging modality improved diagnostic and treatment-planning procedures by providing three-dimensional information with greatly reduced level of radiation dose compared to 2D dental imaging modalitie...

متن کامل

Characterization of Scattered X-Ray Photons in Dental Cone-Beam Computed Tomography

PURPOSE Scatter is a very important artifact causing factor in dental cone-beam CT (CBCT), which has a major influence on the detectability of details within images. This work aimed to improve the image quality of dental CBCT through scatter correction. METHODS Scatter was estimated in the projection domain from the low frequency component of the difference between the raw CBCT projection and...

متن کامل

Fast Scatter Artifacts Correction for Cone-Beam CT without System Modification and Repeat Scan

We provide a fast and accurate scatter artifacts correction algorithm for cone beam CT (CBCT) imaging. The method starts with an estimation of coarse scatter profile for a set of CBCT images. A total-variation denoising algorithm designed specifically for Poisson signal is then applied to derive the final scatter distribution. Qualitatively and quantitatively evaluations using Monte Carlo (MC) ...

متن کامل

A simple, direct method for x-ray scatter estimation and correction in digital radiography and cone-beam CT.

X-ray scatter poses a significant limitation to image quality in cone-beam CT (CBCT), resulting in contrast reduction, image artifacts, and lack of CT number accuracy. We report the performance of a simple scatter correction method in which scatter fluence is estimated directly in each projection from pixel values near the edge of the detector behind the collimator leaves. The algorithm operate...

متن کامل

Noise suppression in scatter correction for cone-beam CT.

Scatter correction is crucial to the quality of reconstructed images in x-ray cone-beam computed tomography (CBCT). Most of existing scatter correction methods assume smooth scatter distributions. The high-frequency scatter noise remains in the projection images even after a perfect scatter correction. In this paper, using a clinical CBCT system and a measurement-based scatter correction, the a...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2010