Automation Control for Blown Film Line
ثبت نشده
چکیده
Blown Film Extrusion is the primary technology used to make plastic films especially for the packaging industry. Its machines produce protective films used in many industries including food and pharmaceuticals – that extend product shelf life and improve consumer appeal. Products such as trash bags, frozen food packaging, shrink wrap, stretch film labeling, form, fill and seal packaging, medical product packaging, and agricultural films are manufactured on blown film lines.
منابع مشابه
Selective Modification of Film Properties through Uniaxial Stretching
The expectations placed on packaging continue to rise. It must provide enhanced product protection, greater convenience and catch the eyes of consumers while offering optimum efficiency and sustainability. Companies producing flexible packaging are responding to these challenges by developing complex, multi-layer composite films and using special raw materials. Whenever this approach reaches it...
متن کاملA thin-shell two-phase microstructural model for blown film extrusion
two-phase microstructural constitutive relation is combined with the thin-shell model for the imulation of blown film extrusion. This combination includes equations for momentum onservation, flow-enhanced crystallization, viscoelasticity, and bubble-tube cooling. Consistent ith typical blown film operation, the simulations set the bubble air mass and take-up ratio as onstants, while treating th...
متن کاملThe influence of bubble mechanics on some properties of blown film
A series of experimental runs were carried out on a small blown film line to investigate the effect of processing parameters on the mechanical properties of the film that was produced. Three different dies were used and for each die the throughput (mass flow rate), freeze line height and blow-up ratio were varied, with take-up velocity adjusted to give a fixed nominal gauge (film thickness). On...
متن کاملThe Effects of Antiblocking Agents on the Performance of Polymer Process Aids
Fluoroelastomer processing aids can improve the melt processibility of polyolefins only by depositing on the internal dies surfaces. It has been shown previously that other additives in the compound can interfere with deposition on the die surface. This present work expands on this knowledge by examining the effectiveness of several commercial processing aids when paired with various antiblocki...
متن کاملNanomaterial-incorporated blown bubble films for large-area, aligned nanostructures
Developing flexible and scalable methods for controlled assembly of nanomaterials remains a critical challenge in nanotechnology. In this article, we review the progress in assembly of nanostructures with a focus on the recently reported method utilizing a bubble expansion process to align one-dimensional nanostructures embedded in blown bubble films. This approach is general and enables effici...
متن کامل