Limitations Imposed on Mixed-Mode Performance of Optimized Phases Due to Temporal Juxtaposition

نویسندگان

  • Thomas B. Berg
  • Shin-Dug Kim
  • Howard Jay Siegel
چکیده

Mixed-mode parallel processing systems are capable of executing in either SIMD (synchronous) or MIMD (asynchronous) mode of parallelism. The ability to switch between the two modes at instruction-level granularity with very little overhead allows the parallelism mode to vary for each portion of an algorithm. To fully exploit the capability of intermixing both SIMD and MIMD operations within a single program, one must determine the optimum mapping of an algorithm to the mixed-mode architecture. The phase optimization technique, where the programmer makes an implicit assumption that by combining the best version of each phase the optimal implementation of the entire program will be achieved, generally works in a serial computer environment. The application of this approach to the selection of a mode of parallelism for each phase is investigated by presenting a detailed study of a practical image-processing application, the Edge-Guided Thresholding algorithm, and its mapping to a mixed-mode parallel architecture. The six functional phases of the algorithm, as well as their temporal juxtaposition, are analyzed along with experimental performance measurements obtained from the PASM parallel processing prototype, a mixed-mode system. The results discussed here demonstrate a situation in which the advantages of a mixedmode approach are limited. o 1991 Academic PM, IIIC.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Impact of Temporal Juxtaposition on the Isolated Phase Optimization Approach to Mapping an Algorithm to Mixed-Mode Architectures

~ Mixed-mode parallel processing systems are capa¬ ble of executing in either SIMD (synchronous) or MIMD (asyn¬ chronous) modes of parallelism. The ability to switch between the two modes at instruction level granularity with very little overhead allows the parallelism mode to vary for each portion of an algorithm. To fully exploit the capability of intermixing both SIMD and MIMD operations wit...

متن کامل

Energy Optimization of Under-actuated Crane model for Time-Variant Load Transferring using Optimized Adaptive Combined Hierarchical Sliding Mode Controller

This paper designs an Optimized Adaptive Combined Hierarchical Sliding Mode Controller (OACHSMC) for a time-varying crane model in presence of uncertainties. Uncertainties have always been one of the most important challenges in designing control systems, which include the unknown parameters or un-modeled dynamics in the systems. Sliding mode controller (SMC) is able to compensate the system in...

متن کامل

AN EXPERIMENTAL INVESTIGATION OF THE SOUNDS OF SILENCE METAHEURISTIC FOR THE MULTI-MODE RESOURCE-CONSTRAINED PROJECT SCHEDULING WITH PRE-OPTIMIZED REPERTOIRE ON THE HARDEST MMLIB+ SET

This paper presents an experimental investigation of the Sounds of Silence (SoS) harmony search metaheuristic for the multi-mode resource-constrained project scheduling problem (MRCPSP) using a pre-optimized starting repertoire. The presented algorithm is based on the time oriented version of the SoS harmony search metaheuristic developed by Csébfalvi et al. [1] for the single-mode resource-con...

متن کامل

Mixed-mode I/II Interlaminar Fracture of CF/PEI Composite Material

Failures in composite materials occur mainly due to interlaminar fracture, also called delamination, between laminates. This indicates that characterizing interlaminar fracture toughness is the most effective factor in the fracture of composite materials. This study reports investigation on mixed-mode interlaminar fracture behaviour in woven carbon fibre/polyetherimide (CF/PEI) thermoplastic co...

متن کامل

Design of an Elastic Arthroplastic Disc Optimized under Different Loads

Introduction: Due to limitations of current treatments for degenerative disc disease, arthroplastic methods to repair the diseased disc have been proposed. The artificial disc is a mobile implant for degenerative disc replacement that attempts to lessen the degeneration of the adjacent elements following interbody fusion procedures. Because the success of artificial disc replacement depends on ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • J. Parallel Distrib. Comput.

دوره 13  شماره 

صفحات  -

تاریخ انتشار 1991