Designing optimized industrial process analysers for closed loop control

Manufacturers are now looking closely at ways of optimizing 'quality' and increasing process efficiency while reducing manufacturing costs. Near infra-red (NIR) technology is a popular solution to this challenge: it provides manufacturers with rapid and reliable in-process analysis and thousands of systems have already been installed in the food, chemical, pharmaceutical and agricultural markets.For over 10 years, NIR has been successfully applied to at-line process analysis. Rugged and easy-to-operate filter analysers are traditionally located in the control room-process operators can then 'grab samples' and obtain results in less than a minute. There are many practical advantages to using at-line filter systems. Products from many lines can be run on one system, and, since there is no direct process interface, installation, operation and maintenance are quite simple.Many manufacturers, however, are now striving to achieve on-line closed loop control, in these cases the benefit of obtaining continuous measurement is well worth the effort required to automate the analysis.