Passive Shimming of MRI Static Magnetic Field Using Regularization of Truncated Singular Value Decomposition

PURPOSE To develop a new shimming calculation method, which can calculate iron piece placements rapidly to make the magnetic field homogeneous at intended homogeneity and then to make the shimming working time short. MATERIALS AND METHODS The shimming calculation yields magnetic moment (MM) distribution, which is calculated by the truncated singular value decomposition (SVD) from the measured magnetic field. The MM distribution is described by a superposition of eigenmodes obtained by SVD of a response matrix from the moment distributions to magnetic fields at the field of view (FOV). The homogeneity is regulated by a truncation number of the superposed eigenmodes. The magnetic moments are converted into iron volumes with the assumption of saturated magnetization and the iron pieces are placed according to the calculation results. Since the SVD calculation can be done in advance, the computational time at the shimming site is short. RESULTS Trial applications on a 0.5T magnetic resonance imaging (MRI) magnet were done using the new shimming calculation method, which was proved to work well. However, since the iron piece volumes had tolerances, the work was repeated until enough homogeneity was obtained. As a result, an intended homogeneity of 8.9 ppm (peak-to-peak) on 40 cm diameter spherical surface was successfully obtained from measured homogeneity of 543 ppm with short computational and working time. CONCLUSION The test shimming work showed that the developed shimming calculation method with truncated SVD regularization is applicable to the shimming work on the MRI magnets.