Large Eddy Simulation of Turbulent Flow in Continuous Casting of Steel
نویسنده
چکیده
During the continuous casting of steel, transient flow events can be very important to the generation of quality problems, such as shear entrainment, surface level fluctuations and bubble entrainment. These phenomena can be better predicted using Large Eddy Simulation (LES) models than the K-ε models, which have been extensively studied. In this work the turbulent transient flow in a water model of a continuous caster has been both simulated using LES models and measured using Particle Image Velocimetry (PIV). The results of PIV and LES have been compared to validate the LES model and also to enhance the understanding of the prominent transient features of the flow field. The flow near the top surface in PIV was found to contain periods of 5-10s when the velocities were three to four times their mean values, which is of importance to the shear entrainment of the liquid flux. In both simulation and PIV the upper roll structure is found to change chaotically from a single large recirculation structure to a set of distinct vortices. The inlet swirl in PIV is seen to persist more than halfway across the mold, causing a characteristic staircase velocity vector pattern when viewed in a plane parallel to the wide faces. The lower rolls in PIV are significantly asymmetric for very long periods of time (~ 1-hour) and go through a repeating sequence of features. One of these features involving a short circuit between the upward and downward flow in the lower roll is also seen in the simulation and is of significance to bubble entrapment.
منابع مشابه
Transient Fluid-Flow Phenomena in the Continuous Steel-Slab Casting Mold and Defect Formation
Phenomena associated with the turbulent flow of molten steel in a continuous casting mold are responsible for many defects in the final product, including surface slivers, frozen meniscus hooks, captured inclusions that enter the mold from upstream, and mold slag entrapment. Animations of some of these transient flow phenomena are presented from Large-Eddy Simulations of a typical slab caster w...
متن کاملInvestigations of Three- Dimensional Turbulent Cavity Flow Using Large Eddy Simulation Approach
متن کامل
Large-eddy simulation of turbulent flow over an array of wall-mounted cubes submerged in an emulated atmospheric boundary-layer
Turbulent flow over an array of wall-mounted cubic obstacles has been numerically investigated using large-eddy simulation. The simulations have been performed using high-performance computations with local cluster systems. The array of cubes are fully submerged in a simulated deep rough-wall atmospheric boundary-layer with high turbulence intensity characteristics of environmental turbulent fl...
متن کاملMathematical Simulation for the Effects of Flow Control Devices in a Six- strand Tundish in Continuous Casting of Steel Billet
The method of continuous casting of steel is now often used in the metallurgical industry, due to the increasing demand for the production of high – quality steel. An important device of continuous casting machine is the tundish, in which a stabilized steel flow has a crucial effect on the quality and efficiency conditions of the continuous casting process. In this study fluid flows in a six – ...
متن کاملTransient Turbulent Flow in a Liquid-Metal Model of Continuous Casting, Including Comparison of Six Different Methods
Computational modeling is an important tool to understand and stabilize transient turbulent fluid flow in the continuous casting of steel to minimize defects. The current work combines the predictions of two steady Reynolds-averaged Navier–Stokes (RANS) models, a ‘‘filtered’’ unsteady RANS model, and two large eddy simulation (LES) models with ultrasonic Doppler velocimetry (UDV) measurements i...
متن کامل