Instrumentation and control of harmonic oscillators via a single-board microprocessor-FPGA device.
نویسندگان
چکیده
We report the development of an instrumentation and control system instantiated on a microprocessor-field programmable gate array (FPGA) device for a harmonic oscillator comprising a portion of a magnetic resonance force microscope. The specific advantages of the system are that it minimizes computation, increases maintainability, and reduces the technical barrier required to enter the experimental field of magnetic resonance force microscopy. Heterodyne digital control and measurement yields computational advantages. A single microprocessor-FPGA device improves system maintainability by using a single programming language. The system presented requires significantly less technical expertise to instantiate than the instrumentation of previous systems, yet integrity of performance is retained and demonstrated with experimental data.
منابع مشابه
Generation of Three-Phase PWM Inverter using Xilinx FPGA and its Application for Utility Connected PV System (RESEARCH NOTE)
Analysis and practical implementation of the regular symmetric sampled three-phase PWM inverter waveform has been presented in this paper. It is digitally implemented on a Xilinx field programmable gate array FPGA, and the essential considerations involved in the feasibility of using a Xilinx XC4008E software-based to generate PWM has been discussed. All the necessary Xilinx hardware/software t...
متن کاملFPGA Implementation of Picoblaze based Embedded System for Monitoring Applications
The microprocessors are used for executing instructions by fetching from memory. The processor interact with other peripherals, it requires additional circuitry .This makes system complexity ,requires large area and high power consumption .To overcome this problem the microprocessor itself capable to handle peripherals up to its limit. This feature comes in Pico Blaze microprocessor. Pico Blaze...
متن کاملAD9410 Prototype Evaluation
This document describes the evaluation of a 200MHz analogue-to-digital converter acquisition evaluation board. The evaluation board contains an AD9410 10-bit ADC [1], which was purchased from Analog Devices for $200. The evaluation board is interfaced via an Altera APEX FPGA to a custom capture card [2]. The APEX FPGA currently contains minimal logic for synchronizing the two data streams from ...
متن کاملFine Tuning of Digital Control in POL Regulators Optimize Dynamic Response and Minimize Component Count
Each electronic circuit on the printed circuit board (PCB) is designed to operate over a limited range of DC voltage, outside of which circuit operation or performance is not guaranteed. A generalized view of the static voltage and associated tolerance is shown in Figure 1. In order to achieve high speed and low power dissipation, recent microprocessor , DSP and FPGA chips require voltage level...
متن کاملAn FPGA-Based Experiment Platform for Hardware Software Co-Design
Microprocessor architecture and digital system design has been a focus of research and the curriculum in the Electrical and Computer Engineering Department (ECEN) at Brigham Young University. There has been continual progress in development of new and efficient architectures and custom digital systems, but these ideas have not had easy access to a design and experiment environment. There has be...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- The Review of scientific instruments
دوره 88 4 شماره
صفحات -
تاریخ انتشار 2017