Extinction measurements for optical band gap determination of soot in a series of nitrogen-diluted ethylene/air non-premixed flames.

نویسندگان

  • Erin M Adkins
  • J Houston Miller
چکیده

Visible light extinction was measured in a series of nitrogen-diluted, ethylene/air, non-premixed flames and this data was used to determine the optical band gap, OBG, as a function of flame position. Collimated light from a supercontinuum source is telescopically expanded and refocused to match the f- number of a dispersing monochromator. The dispersed light is split into a power metering channel and a channel that is periscoped and focused into the flame. The transmitted light is then recollimated and focussed onto a silicon photodiode detector. After tomographic reconstruction of the radial extinction field, the OBG was derived from the near-edge absorption feature using Tauc/Davis-Mott analysis. A slight evolution in OBG was observed throughout all flame systems with a consistent range of OBG observed between approximately 1.85 eV and 2.35 eV. Averaging over all positions the mean OBG was approximately 2.09 eV for all flame systems. Comparing these results to previously published computational results relating calculated HOMO-LUMO gaps for a variety of D2h PAH molecules to the number of aromatic rings in the structure, showed that the observed optical band gap is consistent with a PAH of about 14 rings or a conjugation length of 0.97 nm. This work provides experimental support to the model of soot formation where the transition from chemical to physical growth starts at a modest molecular size; about the size of circumpyrene.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Soot Formation in Laminar Premixed Ethylene/Air Flames at Atmospheric Pressure

Soot formation was studied within laminar premixed ethylene/air flames (C/O ratios of 0.78-0.98) stabilized on a flat-flame burner operating at atmospheric pressure. Measurements included soot volume fractions by both laser extinction and gravimetric methods, temperatures by multiline emission, soot structure by thermophoretic sampling and transmission electron microscopy, major gas species con...

متن کامل

Effect of fuel type on the extinction of fuel and air stream diluted partially premixed flames

Previous investigations have demonstrated that the roles of fuel stream dilution (FSD) and air stream dilution (ASD) in suppressing CO2-diluted methane flames are strongly influenced by the level of partial premixing. Herein, we compare this influence for both counterflow and coflow laminar non-premixed and partially premixed flames (PPFs) established with various fuels, including methane, ethy...

متن کامل

Laser-induced incandescence for soot particle size measurements in premixed flat flames.

Measurements of soot properties by means of laser-induced incandescence (LII) and combined scattering-extinction were performed in well-characterized premixed ethylene-air flames. In particular, the possibility of using LII as a tool for quantitative particle sizing was investigated. Particle sizes were evaluated from the temporal decay of the LII signal combined with heat balance modeling of l...

متن کامل

Suppression of fuel and air stream diluted methane–air partially premixed flames in normal and microgravity

The effects of fuel and air stream dilution (ASD) with carbon dioxide on the suppression of normal and microgravity laminar methane–air partially premixed coflow jet flames were experimentally and numerically investigated. Experiments were conducted both in our normal-gravity laboratory and at the NASA Glenn Research Center 2.2 s drop tower. Measurements included flame topology and liftoff heig...

متن کامل

Use of laser-induced ionization to detect soot inception in premixed flames.

Experimental measurements of laser-induced ionization were performed for ethene-air premixed flames operated near the soot inception point. Soot was ionized with a pulsed laser operated at 532 nm. The ionization signal was collected with a tungsten electrode located in the postflame region. Ionization signals were collected by use of both single-electrode and dual-electrode configurations. Earl...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • Physical chemistry chemical physics : PCCP

دوره 17 4  شماره 

صفحات  -

تاریخ انتشار 2015