Breaking-in Mechanism of the Sliding Surface in a Hermetic Rotary Compressor Employing an Ion-Nitrided Crankshaft
نویسندگان
چکیده
منابع مشابه
CAE Approach to the Development of Rotary Compressors
This paper describes the computer aided engineering (CAE) approach to in,estigate the vibration of rolling piston type rotary compressors in the design and analysis stages. At first, the optimum design procedure for the compressor and piping system is presented. Then ,a compressor data base used for a dynamic simulation of the royary compressors are carried out. Finally, a practical application...
متن کاملAn Experimental Study of the Shaft Oil Supply Mechanism of a Rotary Compressor
This paper describes the experimental study of the shaft oil feed mechanism of a rotary compressor. The oil contained in the shaft in which an oil pump is inserted is fed to the respective sliding surfaces of the subbearing section, eccentric section and main bearing section of the shaft by centrifugal force of shaft rotation. The oil feed pressure of shaft rotation is approximately 0.1 kg/cm2 ...
متن کاملThe Finite Element Analysis of the Deflection of the Crankshaft of Rotary Compressor
The deflection of the crankshaft which transfers the power of motor to the pump of the compressor directly affects the vibration, noise and wear problems in the rotary compressor, therefore, with the requirement of higher reliability, it is important to obtain it exactly in compressor design. Various forces that the crankshaft suffers are calculated by theoretical analysis in the operation proc...
متن کاملVibration Analysis of Rotary Compressors
By theoretically analyzing dynamic behavior of the crankshaft, the rolling piston and the blade inrolling-piston rotary compressors, constraint forces and sliding speed at each pair of movable machine elements were obtained, and unbalanced inertia forces and compressor vibrations were evaluated. It was concluded that theoretical results have a goodagreement with experimental ones. Moreover, it ...
متن کاملAssuring Reliability of Compressors Using HFC Refrigerants
In Japan, the refrigerant used in room air-conditioners has been changed from HCFC-22 (R-22) to R-410A, a blend of HFC-32 and HFC-125 (50/50 vt%), in order to protect the ozone layer. Generally, the miscibility between the refrigerant and refrigeration oil must be assured, because the oil needs to return to the compressor from the refrigeration cycle and lubricate the sliding parts. Alternative...
متن کامل