Bond Graph Modeling of Automotive Transmissions and Drivelines
نویسندگان
چکیده
The paper presents an overview of the bond graph models of advanced automotive transmission and driveline systems. This includes one-mode and two-mode series-parallel hybrid electric vehicle transmissions, a continuous variable transmission, active-limited slip and torque vectoring differentials in 2WD and 4WD configurations, and electromechanical actuator-based wet and dry clutch actuation systems. It is illustrated that the bond graph method can be effectively used to gain valuable insights about the system dynamics structure and behavior.
منابع مشابه
Modeling Torque Converter Characteristics in Automatic Drivelines: Lock-up Clutch and Engine Braking Simulation
A torque converter, which is a hydrodynamic clutch in automatic transmissions, transmits power from the engine shaft to the transmission shaft either by dynamically multiplying the engine torque or by rigidly coupling the engine and transmission shafts. The torque converter is a critical element in the automatic driveline, and it affects the vehicle’s fuel consumption and longitudinal dynamics....
متن کاملAnalysis and Simulation of Multiport Systems the Bond Graph Approach to Physical System Dynamics, Introduction to System Dynamics
Donald L. Margolis, Ronald C. Rosenberg, Wiley, 2012, 111816007X, 9781118160077, 648 pages. An expanded new edition of the bestselling system dynamics book using the bond graph approachA major revision of the go-to resource for engineers facing the increasingly complex job of dynamic systems design, System Dynamics, Fifth Edition adds a completely new section on the control of mechatronic syste...
متن کاملMetamodels for real-time control - an automotive design study
This paper examines the use of metamodels in the context of rapid prototyping for real-time control systems. It is desired that a drive by wire throttle controller be designed to minimise the acceleration oscillations which are a result of the first torsional mode of automotive drivelines. A response surface metamodel is fitted to the output of a complex experimentally verified model of the veh...
متن کاملOn Second Atom-Bond Connectivity Index
The atom-bond connectivity index of graph is a topological index proposed by Estrada et al. as ABC (G) uvE (G ) (du dv 2) / dudv , where the summation goes over all edges of G, du and dv are the degrees of the terminal vertices u and v of edge uv. In the present paper, some upper bounds for the second type of atom-bond connectivity index are computed.
متن کاملGeneration of analytical redundancy relations for fault detection and isolation of ultrasonic linear motor
In this paper Bond Graph modeling, simulation and monitoring of ultrasonic linear motors are presented. Only the vibration of piezoelectric ceramics and stator will be taken into account. Contact problems between stator and rotor (slider) are not treated here. So, standing and travelling waves will be briefly presented since the majority of the motors use another wave type to generate the stato...
متن کامل