Precise Measurement of Semiconductor Laser Chirp Using Effect of Propagation in Dispersive Fiber and Application to Simulation of Transmission Through Fiber Gratings
نویسندگان
چکیده
Measurements of small-signal intensity modulation from direct-modulated distributed feedback (DFB) semiconductor lasers after propagation in dispersive fiber have previously been used to extract intrinsic laser chirp parameters such as linewidth enhancement factor and crossover frequency. Here, we demonstrate that the simple rate equations do not satisfactorily account for the frequency response of real DFB lasers and describe some experimental techniques that conveniently determine the precise laser chirp. Implications for simulation of high-speed lightwave systems are also considered.
منابع مشابه
Analysis of Fiber Bragg Gratings for Dispersion Compensation in Reflective and Transmissive Geometries
Numerical analysis of the dispersion-compensating properties of fiber Bragg gratings (FBG’s) in both reflective and transmissive modes is presented. First, the sensitivity of chirped, reflective gratings to the grating chirp parameter, index modulation, and grating length is examined, showing that apodization provides lower sensitivity to variations in these parameters. Second, we introduce a n...
متن کاملDesign and Application of a Photoacoustic Sensor for Monitoring the Laser Generated Stress Waves in Optical Fiber
Measurement of stress transients generated by a 400ns pulsed HF laser in an infrared fluoride glass fiber has been made using fast time – response piezoelectric film transducer. Acoustic signals up to 12 mV with frequencies ranging in megahertz generated by 21 mJ laser pulse when passed through the fiber axis in the linear region. It is shown that useful information such as onset of non - linea...
متن کاملDegradation of Modulation and Noise Characteristics of Semiconductor Lasers After Propagation in Optical Fiber Due to a Phase Shift Induced by Stimulated Brillouin Scattering
Here we demonstrate theoretically that stimulated Brillouin scattering (SBS) can induce a phase shift of the optical carrier relative to its sidebands due to the waveguiding effect of the optical fiber on the acoustic wave. This causes conversion of frequency modulation to intensity modulation, which results in an increase in the relative intensity noise and degradation of the modulation respon...
متن کاملComposite Cavity Fiber Laser with Asymmetric Output Intensity and Wavelength
The composite cavity fiber laser (CCFL) is relatively simple in its fabrication, as it is essentially three wavelength matched Bragg gratings in a section of doped fiber. By using internal feedback with unequal sub-cavity lengths, unidirectional CCFLs with significantly asymmetric output power from its two outputs can be achieved. Preliminary results also show that it is possible for the lasing...
متن کاملUsing of Broadened Asymmetric Waveguide Structure for 980nm Diode Laser
Laser diode beam divergence is the main parameter for beam shaping and fiber optic coupling. Increasing the waveguide layer thickness is the conventional method to decrease the beam divergence. In this paper, the broadened asymmetric waveguide is introduced to decrease the divergence without increasing the optical power. The asymmetric waveguide was used to shift the vertical optical field to n...
متن کامل