Au-Sn SLID Bonding—Properties and Possibilities
نویسنده
چکیده
Au-Sn solid–liquid interdiffusion (SLID) bonding is a novel and promising interconnect technology for high-temperature applications. This article gives a review over previously published work on Au-Sn SLID bonding. An overview of the crystal phases and the thermomechanical properties of the Au-Sn phases relevant for Au-Sn SLID bonding is given. A summary of the bonding conditions used during Au-Sn SLID bonding is presented together with results from reliability tests. Additional challenges, possibilities, and recommendations for how a reliable high-temperature Au-Sn SLID bonding should be constructed are also discussed.
منابع مشابه
Effect of Surface Finish of Substrate on Mechanical Reliability of in-48SN Solder Joints in Moems Package
Interfacial reactions and shear properties of the In-48Sn (in wt.%) ball grid array (BGA) solder joints after bonding were investigated with four different surface finishes of the substrate over an underlying Cu pad: electroplated Ni/Au (hereafter E-NG), electroless Ni/immersion Au (hereafter ENIG), immersion Ag (hereafter I-Ag) and organic solderability preservative (hereafter OSP). During bon...
متن کاملHigh Temperature Electronics Packaging
Materials and processes are being developed for packaging of low and medium power, high temperature electronics (up to 500). Ceramic (Al2O3 and AlN) hermetic packages are being used. Die attach techniques based on patterned Au bumps, Au-Si and off-eutectic Au-Sn have been demonstrated. Au thermosonic wire bonding provides a monometallic interconnect system between the die and the package pads. ...
متن کاملReconstruction and thermal performance analysis of die-bonding filling states for high-power light-emitting diode devices
This paper proposed a half-experimental model to reconstruct the die-bonding thermal path of highpower light-emitting diodes (HP-LEDs). In this model, the partially insufficient filling of bonding materials and their directional/random distributions (“filling state” for short) have been taken into consideration. Both the silver-paste structure and the Au/Sn-eutectic structure were analyzed and ...
متن کاملLow Temperature Transient Liquid Phase (LTTLP) Bonding for Au/Cu and Cu/Cu Interconnections
The Low Temperature Transient Liquid Phase Diffusion Bonding (L TTLP) process has been used to reduce the residual stresses and hence, improve the thermal fatigue performance of bonds between dissimilar electronic packaging materials. Aluminum oxide plated with either gold or copper has been bonded to copper heatsinks at temperatures less than 160°C using In-Sn eutectic solders. After two hour...
متن کاملFluxless silicon-to-alumina bonding using electroplated Au–Sn–Au structure at eutectic composition
Large 6 mm× 9 mm silicon chips have been successfully bonded to alumina substrates with electroplated Au/Sn/Au structure at the eutectic omposition. The new bonding process is entirely fluxless, or flux-free. It is performed in vacuum (50 milliTorrs), where the oxygen content is educed by a factor of 15,200 comparing to air, to inhibit solder oxidation. Eutectic Au80Sn20 alloy is a well establi...
متن کامل