Elastomeric nanoparticle composites covalently bound to Al2O3/GaAs surfaces.

نویسندگان

  • Hyon Min Song
  • Peide D Ye
  • Albena Ivanisevic
چکیده

This article reports the modification of Al2O3/GaAs surfaces with multifunctional soft materials. Siloxane elastomers were covalently bound to dopamine-modified Al2O3/GaAs semiconductor surfaces using MPt (M = Fe, Ni) nanoparticles. The sizes of the monodisperse FePt and NiPt nanoparticles were less than 5 nm. The surfaces of the nanoparticles as well as the Al2O3/GaAs substrates were modified with allyl-functionalized dopamine that utilized a dihydroxy group as a strong ligand. The immobilization of the elastomers was performed via a hydrosilation reaction of the allyl-functionalized dopamines with the siloxane backbones. X-ray photoelectron spectroscopy (XPS) experiments confirmed the covalent bonding of the siloxane elastomers to the oxide layer on the semiconductor surface. Fourier transform-infrared reflection absorption spectroscopy (FT-IRRAS) measurements revealed that the allyl functional groups are bonded to the siloxane backbones. The FT-IRRAS data also showed that the density of the allyl groups on the surface was lower than that of the siloxane backbones. The mechanical properties of the surface-bound nanocomposites were tested using nanoindentation experiments. The nanoindentation data showed that the soft matrix composed of the elastomeric coating on the surfaces behaves differently from the inner, hard Al2O3/GaAs substrate.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Catalytic microcontact printing on chemically functionalized H-terminated silicon.

We report a novel inkless soft lithographic fabrication protocol that permits uniform parallel patterning of hydrogen-terminated silicon surfaces using catalytic elastomeric stamps. Pattern transfer is achieved catalytically via reaction between sulfonic acid moieties covalently bound to an elastomeric stamp and a Boc-functionalized SAM grafted to passivated silicon. The approach represents the...

متن کامل

An Investigation of the Fatigue Induced Failure Modes

It is proposed to use elastomeric composites as artificial joint bearing surfaces to increase their fluid film lubrication and therefore reduce the number of failures which have been attributed to wear mechanisms. The fluid generated between the surfaces supports part of the load and prevents direct contact of the bearing surfaces. However, permanent deformation and failure of model elastomeric...

متن کامل

DNA probes on chip surfaces studied by scanning force microscopy using specific binding of colloidal gold.

Single-stranded DNA was covalently bound on chip surfaces using two different silanization procedures. The resulting surfaces were characterized by fluorescence and scanning force microscopy using sequence-complementary DNA molecules with labels. Colloidal gold (30 nm) was used as the topographic label. Scanning force microscopy revealed the individual labels on the surface and their distributi...

متن کامل

An Investigation of the Fatigue Induced Failure Modes of Fiber/Elastomer Composites as Bearing Surfaces in Total Hip Joint Prosthesis

It is proposed to use elastomeric composites as artificial joint bearing surfaces to increase their fluid film lubrication and therefore reduce the number of failures which have been attributed to wear mechanisms related to frictional forces. The fluid generated between the surfaces supports part of the load and prevents direct contact of the bearing surfaces. In order to obtain optimum elastoh...

متن کامل

Studying on the fatigue behavior of Al- Al2O3 metal matrix nano composites processed through powder metallurgy

Excellent mechanical properties and fatigue performance of Al/Al2O3 metal-based nanocomposites caused to introduce this material as a good candidate for various applications. In this regard, the preparation and characterization of this composite can be considered as a hot issue for research. The study was carried out in several steps including: (i) preparation of Al/Al2O3 metal-based nanocompos...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Langmuir : the ACS journal of surfaces and colloids

دوره 23 18  شماره 

صفحات  -

تاریخ انتشار 2007