Design of Extrusion Heads
نویسنده
چکیده
منابع مشابه
Back Calculation of the End Pressure of Circular Capillaries by means of Measurements of Slit Capillaries
The dimensioning of injection heads for the extrusion of rubber profiles is exclusively based on empiric knowledge of the non-linear flow behaviour of elastomers. Thus, the design of injection heads is carried out with subject to the used rubber blend, whereas the geometry of the appropriate profile is achieved by empiric adaptation of the extrusion die. This was one of the motivations for a re...
متن کاملInfluence of Crystallization and Filler Degree on Viscoelastic Properties of Rubber Compounds
The dimensioning of injection heads for the extrusion of rubber profiles is exclusively based on empiric knowledge of the non-linear flow behavior of elastomers. Thus, the design of injection heads is carried out with subject to the used rubber compound, whereas the geometry of the appropriate profile is achieved by empiric adaptation of the extrusion die. This was one of the motivations for a ...
متن کامل4_A_0930 Doc
The dimensioning of injection heads for the extrusion of rubber profiles is exclusively based on empiric knowledge of the non-linear viscoelastic flow behaviour of elastomers especially of the so-called die swell.Thus, the design of injection heads is carried out with subject to the used rubber blend, whereas the geometry of the appropriate profile is achieved by empiric adaptation of the extru...
متن کاملParameter Analysis and optimization of equal channel angular pressing extrusion for titanium alloy using Taguchi design of experiments method
In this paper the influence of different parameters on equal channel angular pressing (EADAP) of titanium alloy is investigated. In the first step the most important parameters are selected, and then a table of experiments is designed using Taguchi method. After designing the table of experiments, all of the experiments are simulated using Abacus software and the results are optimized using Tag...
متن کاملSimulation of a New Process Design to Fabricate a Rectangular Twist Waveguide Using Extrusion and a Twist Die
The aim of the present study is to determine the feasibility of making a rectangular twist waveguide used to rotate electromagnetic waves. For this purpose, the process of fabricating an aluminum rectangular twist waveguide was simulated by making use of finite element method and Deform software. The optimum length and angle of the twist die for manufacturing a twist waveguide with inner cross ...
متن کامل