The Influence of Plain Bearings on Shaft Whirling
نویسنده
چکیده
منابع مشابه
Dynamic Analysis of Multi Mass Counter Rotor System with Integral S-shaped Squeeze Film Damper
In order to reduce the mass, the new designs of turbojet engines use rotors working with higher speeds. These rotors are subjected to large unbalance during engine operational conditions. An additional damping might be necessary in order to enable working at rotation speeds higher than the critical ones. In order to achieve this objective, Integral S-shaped Squeeze Film Damper (ISSFD) and Multi...
متن کاملStudy of Permanent Magnet Bearings and their Stiffness
A typical passive magnetic bearing has been modeled and analyzed for its performance characteristics. The magnetic bearing studied in this work comprised of a Shaft, inner magnets sleeved over the shaft, and outer magnetic rings. A detailed analysis has been perform on the force exerted by a permanent magnet on the shaft nurture to restore the shaft to its equilibrium position when an eccentric...
متن کاملThe Effect of Damping and Stiffness of Bearing on the Natural Frequencies of Rotor-bearing System
In this paper, the effectiveness of stiffness and damping of bearing is investigated on the natural frequencies of the rotor-bearing system. The rotor-bearing system consists of a shaft, two bearings and a disk between two bearings. Parallel spring-damper in horizental and vertical directions is considered for modeling the stiffness and damping of bearings. The gyroscopic effect is also conside...
متن کاملNumerical Analysis of Grease Film Characteristics in Tapered Roller Bearing Subject to Shaft Deflection
The shaft deflection is one of critical factors that deteriorate the grease lubrication state inside the tapered roller bearings (TRBs). So, in this paper, on the premise of the TRB subjected to the combined loads and the shaft is deflected, the grease lubrication model at the TRB contacts was constructed, in which the interaction loads, linear and angular displacements of the bearing parts wer...
متن کاملTitle: Influence of actuator geometry on rotating losses in heteropolar magnetic bearings
Recently, work on rotating losses in magnetic bearings has focused mainly on the measurement of rotating losses, and on the creation of models that attempt to reproduce these results. Though there has been some success on both counts, there has been less emphasis on interpreting what these results mean in terms of practical guidelines for the design of low-loss bearings. The present work reform...
متن کامل