The Effect of Three-dimensionality on the Radiation Forces of Surface Piercing Bodies
نویسندگان
چکیده
منابع مشابه
Comparison of Lift and Drag Forces for Some Conical Bodies in Supersonic Flow Using Perturbation Techniques
Numerical methods are not always convergent especially in higher velocities when shock waves are involved. A comparison analysis is performed to study the supersonic flow over conical bodies of three different cross sections circular, elliptic and squircle (square with rounded corners) shaped using Perturbation techniques to find flow variables analytically. In order to find lift and drag forc...
متن کاملDesign Algorithm of a Free Surface Water Tunnel to Test the Surface-Piercing Propellers (SPP); Case Study Water Tunnel of Babol Noshirvani University of Technology
Surface-Piercing Propellers (SPPs) have been widely used in high speed craft due to some desirable features such as high efficiency, omission of resistance of equipment attached to the propeller and proper functioning of cavitation. Unlike the submerged propellers, theoretical methods have no significant application on simulation of SPPsbecause of problems related to modeling of these propeller...
متن کاملLocation and dimensionality estimation of geological bodies using eigenvectors of "Computed Gravity Gradient Tensor"
One of the methodologies employed in gravimetry exploration is eigenvector analysis of Gravity Gradient Tensor (GGT) which yields a solution including an estimation of a causative body’s Center of Mass (COM), dimensionality and strike direction. The eigenvectors of GGT give very rewarding clues about COM and strike direction. Additionally, the relationships between its components provide a quan...
متن کاملBOUNDARY ELEMENT METHOD APPLIED TO THE LIFTING BODIES NEAR THE FREE SURFACE
In this study, the boundary element method is formulated to evaluate hydrodynamic characteristics of bodies including free surface effect. The method is based on two equations, the perturbation potential boundary integral and the pressure Kutta condition, which are solved simultaneously. The method uses isoparametric elements for both quantity and geometric on the boundary. The method is first ...
متن کاملThe Effect of Artificial Aging Treatment and Lubrication Modes on the Cutting Force and the Chip Surface Morphology when Drilling Al-Si-Mg (A356) Cast Alloys
This article reports the effects of various artificial aging methods and lubrication modes (dry, mist, wet) on the recorded cutting forces and chip morphology in drilling Al-Si-Mg (A356) cast alloys. In the course of this work, the work part sampled were as-received alloy (T0), solution heat-treated alloy (SHT) and then aged alloys at 155°C, 180°C, and 220°C (T4, T6, T61, T7), respectively. The...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2014