Homeopathic Preparations of Quartz, Sulfur and Copper Sulfate Assessed by UV-Spectroscopy
نویسندگان
چکیده
Homeopathic preparations are used in homeopathy and anthroposophic medicine. Although there is evidence of effectiveness in several clinical studies, including double-blinded randomized controlled trials, their nature and mode of action could not be explained with current scientific approaches yet. Several physical methods have already been applied to investigate homeopathic preparations but it is yet unclear which methods are best suited to identify characteristic physicochemical properties of homeopathic preparations. The aim of this study was to investigate homeopathic preparations with UV-spectroscopy. In a blinded, randomized, controlled experiment homeopathic preparations of copper sulfate (CuSO(4); 11c-30c), quartz (SiO(2); 10c-30c, i.e., centesimal dilution steps) and sulfur (S; 11×-30×, i.e., decimal dilution steps) and controls (one-time succussed diluent) were investigated using UV-spectroscopy and tested for contamination by inductively coupled plasma mass spectrometry (ICP-MS). The UV transmission for homeopathic preparations of CuSO(4) preparations was significantly lower than in controls. The transmission seemed to be also lower for both SiO(2) and S, but not significant. The mean effect size (95% confidence interval) was similar for the homeopathic preparations: CuSO(4) (pooled data) 0.0544% (0.0260-0.0827%), SiO(2) 0.0323% (-0.0064% to 0.0710%) and S 0.0281% (-0.0520% to 0.1082%). UV transmission values of homeopathic preparations had a significantly higher variability compared to controls. In none of the samples the concentration of any element analyzed by ICP-MS exceeded 100 ppb. Lower transmission of UV light may indicate that homeopathic preparations are less structured or more dynamic than their succussed pure solvent.
منابع مشابه
Differences in Median Ultraviolet Light Transmissions of Serial Homeopathic Dilutions of Copper Sulfate, Hypericum perforatum, and Sulfur
Homeopathic remedies are produced by potentising, that is, the serial logarithmic dilution and succussion of a mother tincture. Techniques like ultraviolet spectroscopy, nuclear magnetic resonance, calorimetry, or thermoluminescence have been used to investigate their physical properties. In this study, homeopathic centesimal (c) potencies (6c to 30c) of copper sulfate, Hypericum perforatum, an...
متن کاملComparative XPS Study of Silver and Copper Surfaces Exposed to Flowing Air Containing Low Concentration of Sulfur Dioxide
Sulfur dioxide (SO2), a typical gaseous compound found in the atmosphere, corrodes metals, particularly outdoors. When SO2 adsorbs on the surface electrolyte, it easily dissolves, resulting in the formation of protons (H+) and bisulfite ions (HSO3). The former reduces the pH of the surface electrolyte, which promotes metal dissolution. Silver and copper are commonly used in the electronic compo...
متن کاملInfluence of Humidity, Sulfur Dioxide, Ozone and Nitrogen Dioxide on Copper
This thesis presents a new experimental setup for surface analysis studies, incorporating chemical information from infrared reflection absorption spectroscopy (IRAS) and quantitative information from quartz crystal microbalance (QCM). The integrated IRAS/QCM surface analysis system enables in situ studies to be conducted of the metal/atmosphere interaction on a sub-monolayer level. In combinat...
متن کاملHydrothermal evolution of the Sar-Kuh porphyry copper deposit, Kerman, Iran: A fluid inclusion and sulfur isotope investigation
Sar-Kuh porphyry copper deposit is located 6 km southwest of the Sar-Cheshmeh copper mine, Kerman Province, Iran. Based on field geology, petrography and fluid inclusions studies, four alteration types have been identified in the Sar-Kuh area. Early hydrothermal alteration formed a potassic zone in the central parts of Mamzar granite/grano-diorite stock and propylitic alteration in its peripher...
متن کاملLow-cost 3D printed 1 nm resolution smartphone sensor-based spectrometer: instrument design and application in ultraviolet spectroscopy.
We report on the development of a low-cost spectrometer, based on off-the-shelf optical components, a 3D printed housing, and a modified Raspberry Pi camera module. With a bandwidth and spectral resolution of ≈60 nm and 1 nm, respectively, this device was designed for ultraviolet (UV) remote sensing of atmospheric sulphur dioxide (SO2), ≈310 nm. To the best of our knowledge, this is the first...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
دوره 2011 شماره
صفحات -
تاریخ انتشار 2011