In vitro development of haploid mouse embryos produced by bisection of one-cell fertilized eggs.

Fi(CBA x C57BL/10) mouse eggs originating from spontaneous or induced ovulation and fertilized by CBA-T6T6 or PO spermatozoa were bisected with a glass needle into halves each containing a pronucleus.This technique offers a unique opportunity of producing both androgenetic and gynogenetic haploid embryos from one egg. Out of 600 operated eggs, in 406 (67-7%) both halves survived. During 96 h of culture in vitro the fragments were inspected once daily and finally examined in air-dried preparations. Eighty-seven per cent of halves underwent first cleavage but their further development was to a large extent affected by extrinsic factors connected with experimental procedure (mainly by suboptimal and variable culture conditions) and by the origin of eggs (those from spontaneous ovulation being superior). For this reason developmental capabilities of egg halves were assessed in a selected group of pairs in which at least one partner reached the stage of four or more blastomeres. The observed ratio between pairs with both or only one sister embryo developing successfully suggests that androgenetic embryos carrying F rather than X chromosome can cleave twice but do not survive beyond 4-cell stage. None of the metaphase plates from older embryos contained a Y chromosome. These observations imply that the X chromosome is genetically active during early cleavage and that a full haploid set is required for preimplantation development to be completed. Formation of blastocysts varied from batch to batch, with an average of 12-8% and maximal incidence of 29-5 %. In 34 pairs both fragments developed beyond the 4-cell stage but in only one case did both form blastocysts. Haploid blastocysts were composed of 27 cells on average which was about a half of the number of cells in control diploid zona-free whole eggs. Ten out of 51 embryos with metaphase plates proved to be haploid/diploid mosaics.