CCN activity and droplet growth kinetics of fresh and aged monoterpene secondary organic aerosol

The ability of secondary organic aerosol (SOA) produced from the ozonolysis of α-pinene and monoterpene mixtures (α-pinene, β-pinene, limonene and 3-carene) to become cloud droplets was investigated. A static CCN counter and a Scanning Mobility CCN Analyser (a Scanning Mobility Particle Sizer coupled with a Continuous Flow counter) were used for the CCN measurements. Consistent with previous studies monoterpene SOA is quite active and would likely be a good source of cloud condensation nuclei (CCN) in the atmosphere. A decrease in CCN activation diameter for α-pinene SOA of approximately 3 nm hr−1 was observed as the aerosol continued to react with oxidants. Hydroxyl radicals further oxidize the SOA particles thereby enhancing the particle CCN activity with time. The initial concentrations of ozone and monoterpene precursor (for concentrations lower than 40 ppb) do not appear to affect the activity of the resulting SOA. Köhler Theory Analysis (KTA) is used to infer the molar mass of the SOA sampled online and offline from atomized filter samples. The estimated average molar mass of online SOA was determined to be 180±55 g mol−1 (consistent with existing SOA speciation studies) assuming complete solubility. KTA suggests that the aged aerosol (both from α-pinene and the mixed monoterpene oxidation) is primarily water-soluble (around 65%). CCN activity measurements of the SOA mixed with (NH4)2SO4 suggest that the organic can depress surface tension by as much as 10 N m−1 (with respect to pure water). The droplet growth kinetics of SOA samples are similar to (NH4)2SO4, except at low supersaturation, where SOA tends to grow more slowly. The CCN activation diameter Correspondence to: S. N. Pandis ([email protected]) of α-pinene and mixed monoterpene SOA can be modelled to within 10–15% of experiments by a simple implementation of Köhler theory, assuming complete dissolution of the particles, no dissociation into ions, a molecular weight of 180 g mol−1, a density of 1.5 g cm−3, and the surface tension of water.