Development of an air-stable, high energy density printed silver oxide battery for printed electronics

Permission to make digital or hard copies of all or part of this work for personal or classroom use is granted without fee provided that copies are not made or distributed for profit or commercial advantage and that copies bear this notice and the full citation on the first page. To copy otherwise, to republish, to post on servers or to redistribute to lists, requires prior specific permission. Development of an air-stable, high energy density printed silver oxide battery for printed electronics Abstract Development of an air-stable, high energy density printed silver oxide battery for printed electronics Printed batteries are emerging battery technology that has the potential to enable the production of cheap, small form factor, flexible batteries capable of powering a diverse set of existing and emerging applications such as RFID tags, flexible displays, and distributed sensors. Partially printed battery systems have been demonstrated with various chemistries, but what is needed is a low cost, air stable method of fully printing a high energy density batteries. The silver oxide chemistry is attractive for developing a printed battery as this chemistry has demonstrated high energy densities and is capable of air stable fabrication processes due to its aqueous based chemistry. To facilitate the advancement of this technology, material components and printing techniques need to be developed to demonstrate a printed silver oxide battery. In this thesis, I will present a printed, high energy density silver oxide battery using stencil printing. A key development of this work is the demonstration of a novel photopolymerized polyacrylic acid separator layer. The mechanical and conductivity properties of this layer are characterized and optimized for an alkaline silver oxide battery. The incorporation of this layer has enabled a printed battery capable of high rates of discharge. The batteries show no difference in discharge upon flexing at a bend radius of 1.0 cm, indicating their potential in flexible applications. The fabricated batteries have demonstrated high energy densities of 10 mWhr cm-3 and areal capacities of 5.4 mAhr cm-2 , which satisfies the power and capacity requirements for most of the proposed applications. In addition, we have examined several printed encapsulation schemes (epoxy and silicone caulk) for encapsulating an alkaline battery.