Downhole Receiver Function: a Case Study
نویسندگان
چکیده
Receiver function is defined as the spectral ratio of the radial component and the vertical component of the ground motion. It is used to characterize converted waves. We extend the use of the receiver function to downhole data using waves recorded in a borehole, excited by an earthquake of magnitude 4.0 near San Francisco, California, on 26 June 1994. The focal depth of the event was 6.6 km and the epicenter was located at a distance of 12.6 km from the borehole array. Six threecomponent sensors were located at different depths in a borehole. To extract a coherent response of the near-surface from the incoherent earthquake waves, we deconvolve the waves recorded by the sensors at different depths with the waves recorded by the sensor on the surface. Deconvolution applied to the waves in the Stime window recorded by the radial component result in an upgoing and a downgoing wave propagating with S-wave velocity. For the waves in the P-time window recorded by the radial component, deconvolution also gives an upgoing and a downgoing wave propagating with S-wave velocity. This interesting result suggests a Pto-S conversion at a depth below the deepest sensor. To diagnose this we compute the receiver function for the borehole recording of the earthquake waves. The receiver function shows an upgoing wave with an arrival close to time t ! 0 for the deepest sensor. The agreement of the upgoing wave in the receiver function with the traveltime curve for the P-to-S converted wave, calculated using the Pand the S-wave velocity profile, supports the hypothesis of a pronounced P-to-S conversion. We present a synthetic example to illustrate that the first arrival of the receiver function applied to borehole data gives the upward-propagating P-to-S converted wave. To corroborate the observation of the mode conversion, we apply receiver function to a different earthquake data recorded by the same borehole array in 1998. The focal depth of the event was 6.9 km and the epicenter was located at a distance of 13 km from the borehole array. The receiver function for these data also show an upgoing wave with a pulse close to time t ! 0 at the deepest sensor. The moveout of the upgoing wave agrees with the travel-time curve for the P-to-S converted wave, hence supporting our observation of the mode conversion.
منابع مشابه
Interpretation of resonance frequencies recorded during hydraulic fracturing treatments
Hydraulic fracturing treatments are often monitored by strings of geophones deployed in boreholes. Instead of picking discrete events only, we here use time-frequency representations of continuous recordings to identify resonances in two case studies. This paper outlines an interpretational procedure to identify their cause using a subdivision into source, path, and receiver-side effects. For t...
متن کاملControlled-source interferometric redatuming by crosscorrelation and multidimensional deconvolution in elastic media
Various researchers have shown that accurate redatuming of controlled seismic sources to downhole receiver locations can be achieved without requiring a velocity model. By placing receivers in a horizontal or deviated well and turning them into virtual sources, accurate images can be obtained even below a complex near-subsurface. Examples include controlled-source interferometry and the virtual...
متن کاملUrban Inundation Hazard Potential using Evidential Belief Function model (EBF) (Case study: Emam Ali town, Mashhad city)
Inundation in urban areas due to dens storm has created many problems for all cities thorough the world. Urban flood hazard zoning may provide useful information for dealing with contingency and alleviating risk and loss of life and property. Therefore, to management of urban area, flood relief measures and prioritized to address flooding problems should be identified areas that are more aff...
متن کاملOFDM Wireless Downhole Transmission Systems and Proposed SLM Method for PAPR Reduction
At present, mud pulse transmission systems are widely used in downhole data transmission. But the systems are very low in transmission efficiency, only 5 10 bits/s, with very large anti-inter-symbol-interference (ISI). It cannot meet high requirements for high-speed transmission of modern logging system. The development of communication technology has laid some foundation for this requirement. ...
متن کاملDesigning a High Resistant, High-torque Downhole Drilling Motor (RESEARCH NOTE)
Downhole drilling motors or mud motors are frequently used during the oil and gas well construction, especially for construction of directional and horizontal segments. However, low operation life of the down hole drilling motors and high rate of wear in their working elements may constrain their application due to technical and economical disadvantageousness. In this work, a high-torque modula...
متن کامل