Steel Mill Products Analysis Using Qualities Methods

B. Gajdzik, The Silesian University of Technology, Faculty of Materials Science and Metallurgy, Katowice, Poland J. Sitko, The Silesian University of Technology, Faculty of Organization and Management, Zabrze, Poland The article presents the subject matter of steel mill product analysis using quality tools. The subject of quality control were bolts and a ball bushing. The Pareto chart and fault mode and effect analysis (FMEA) were used to assess faultiness of the products. The faultiness analysis in case of the bolt enabled us to detect the following defects: failure to keep the dimensional tolerance, dents and imprints, improper roughness, lack of pre-machining, non-compatibility of the electroplating and faults on the surface. Analysis of the ball bushing has also revealed defects such as: failure to keep the dimensional tolerance, dents and imprints, improper surface roughness, lack of surface premachining as well as sharp edges and splitting of the material.