Surface Sensitive Techniques for Advanced Characterization of Luminescent Materials
نویسنده
چکیده
The important role of surface sensitive characterization techniques such as Auger electron spectroscopy (AES), X-ray photo electron spectroscopy (XPS), time of flight scanning ion mass spectrometry (TOF-SIMS) and High resolution transmission electron microscopy (HRTEM) for the characterization of different phosphor materials is discussed in this short review by giving selective examples from previous obtained results. AES is used to monitor surface reactions during electron bombardment and also to determine the elemental composition of the surfaces of the materials, while XPS and TOF-SIMS are used for determining the surface chemical composition and valence state of the dopants. The role of XPS to determine the presence of defects in the phosphor matrix is also stated with the different examples. The role of HRTEM in combination with Energy dispersive spectroscopy (EDS) for nanoparticle characterization is also pointed out.
منابع مشابه
Preparation and Characterization of High Specific Surface Area γ-Alumina Nanoparticles Via Sol-Gel Method
In the present investigation, γ-alumina nanoparticles with particle sizes less than 10 nm, high specific surface area (351 m2/g), high pore volumes and relatively narrow pore sizes distribution was prepared via sol-gel method in presence of aluminum isopropoxide as an aluminum precursor, distilled water, acetic acid as hydrolysis rate controller and tert-butanol as solvent. They had meso ...
متن کاملCharacterization of nanostructured SnO2 thin film coated by Ag nanoparticles
Nanostructured SnO2 thin films were prepared using Electron Beam-Physical Vapor Deposition (EB-PVD) technique. Then Ag nanoparticles synthesized by laser-pulsed ablation were sprayed on the films. In order to form a homogenous coated of SnO2 on the glass surface, it was thermally treated at 500°C for 1 h. At this stage, the combined layer on the substrate was completely dried for 8 h in the air...
متن کاملCathodic Electrodeposition and Characterization of YAG Nanostructure: Effect Current Density on the Morphology
Abstract YAG (Yttrium Aluminum Garnet) was successfully prepared through cathodic electrodeposition process using applying different current densities to the mixture of YCl3 and AlCl3 dissolved in water/ethanol 1:1 solution. Hydroxide precursors were cathodically grown on the cathode surface (at different current densities) and then the obtained hydroxide powder was heat-treated at 1100 °...
متن کاملBismuth Pyromangenate: Hydrothermal and Solid State Synthesis, Characterization and Optical Properties
Bi2Mn2O7 nano-powders were synthesized via a stoichiometric 1:1 Bi:Mn molar ratio hydrothermal method at 180 °C for 48 h in a 1M NaOH aqueous solution; and solid state method, using Bi(NO3)3.5H2O and MnO2 as raw materials. The synthesized materials were characterized by powder X-ray diffraction (PXRD) technique. Also, the rietveld analysis was done in FullProf in profile matching mode. It was f...
متن کاملCharacterization of Luminescent Down-Shifting Materials and Applications for PV Devices
Enhancement in the performance of Silicon solar cell can be achieved via luminescent down-shifting (LDS) of the incident light. Lumogen Violet dye and Tb(ant)3.2H2O complex were characterized to determine their suitability for inclusion in LDS layers. LDS layer characterization techniques are discussed and preliminary results from PV cell/LDS layer devices are presented.
متن کامل