Experimental evaluation of four-phase floating interleaved boost converter design and control for fuel cell applications
نویسندگان
چکیده
Power electronic converters are essential part of hybrid fuel cell automotive application systems. The converter needs to provide high-voltage ratio for a wide range of input voltage. In addition, the converter should have high efficiency for a wide range of duty cycle control range. A four-phase floating interleaved boost converter (FIBC) is analysed and a small-signal AC model using an averaged pulse-width modulation (PWM) switch technique is used for supporting the feedback controller and aiding a frequency response design. The small-signal AC model as well as the current controller are validated by simulation and evaluated by experimental results. The proposed converter has competitive device ratings, the total inductance volume and weight is decreased, current ripple is minimised and converter efficiency and reliability are improved. Proof of concept of the proposed topology is demonstrated through an experimental prototype.
منابع مشابه
Implementation of Floating Output Interleaved Input DC-DC Boost Converter
This paper presents the analysin ,design and implementation of a high voltage ratio topology of DC-DC converter. The DC-DC converter has high voltage ratio with reduced input current, output voltage and output current ripple, and also reduces the voltage and current rating of power electronics components and compared with conventional boost converter. The voltage stress on the switches are red...
متن کاملA Novel Interleaved DC-DC Converter with Reduced Loss for Fuel Cell Vehicle Application
In this paper a novel four-leg interleaved DC-DC boost converter is proposed which is well suitable for fuel cell vehicles (FCV) application. The voltage stress of two switches of this converter is half of the conventional interleaved converters. Therefore, smaller and cheaper switches can be utilized. Also "on" state duration of the two of four switches are reduced in comparison with...
متن کاملAn Interleaved Configuration of Modified KY Converter with High Conversion Ratio for Renewable Energy Applications; Design, Analysis and Implementation
In this paper, a new high efficiency, high step-up, non-isolated, interleaved DC-DC converter for renewable energy applications is presented. In the suggested topology, two modified step-up KY converters are interleaved to obtain a high conversion ratio without the use of coupled inductors. In comparison with the conventional interleaved DC-DC converters such as boost, buck-boost, SEPIC, ZETA a...
متن کاملAnalysis and Experimentation of Soft Switched Interleaved Boost Converter for Photovoltaic Applications
Conventional energy sources are fast depleting due to poor conservation practises and excessive usage while the world’s energy demands are growing by minute. Additionally, the cost of producing conventional energy is rising also leading to an increase in harmful environmental pollution. Hence, there is a need to look at alternative energy sources such as sun, water and wind. Photovoltaic (PV) i...
متن کاملAsymmetrical Interleaved DC/DC Switching Converters for Photovoltaic and Fuel Cell Applications—Part 1: Circuit Generation, Analysis and Design
A novel asymmetrical interleaved dc/dc switching converters family intended for photovoltaic and fuel cell applications is presented in this paper. The main requirements on such applications are small ripples in the generator and load, as well as high voltage conversion ratio. Therefore, interleaved structures and voltage multiplier cells have been asymmetrically combined to generate new conver...
متن کامل