Design of an Auxiliary Power Distribution Network for an Electric Vehicle
نویسندگان
چکیده
This paper presents the design of an auxiliary power distribution network for an electric vehicle. Efficiency is a key element in the design for any electric vehicle and a 48Vdc distribution network will be used throughout the vehicle. The high efficiency Cuk converter has been selected as the most appropriate topology to supply the various distributed loads. To achieve the best compromise between efficiency and component sizes, a switching frequency of 100kHz is used. The results from simulations and experimental measurements are discussed and a range of proposals is also made to modify some of the existing loads to further improve efficiency.
منابع مشابه
Probabilistic Allocation Of Parking lots In Distribution Network Considering Uncertainty.
In this paper, parking lots with bidirectional power flow capability, is used as an achievements of smart power systems. Based on operating conditions, electric vehicles can be considered as a load or generator. For optimal operation of power systems, allocation of these novel units is also necessary same as other distributed generation. In this paper, an optimization problem is proposed for...
متن کاملA Novel Intelligent Energy Management Strategy Based on Combination of Multi Methods for a Hybrid Electric Vehicle
Based on the problems caused by today conventional vehicles, much attention has been put on the fuel cell vehicles researches. However, using a fuel cell system is not adequate alone in transportation applications, because the load power profile includes transient that is not compatible with the fuel cell dynamic. To resolve this problem, hybridization of the fuel cell and energy storage device...
متن کاملProviding a Method of Intelligent Charging of Electric Vehicles with Discrete Rates with the Aim of Flattening Load Profile and Reducing Number of Switching Times
From the point of view of network operation, the lack of proper management of electric vehicles in the network can change the load profile of the network and causes numerous peaks and valleys in it, which is not appropriate from the perspective of network operators. In this paper, an intelligent charging strategy in which according to the information recorded by drivers such as the length of th...
متن کاملParameters Design and Economy Study of an Electric Vehicle with Powertrain Systems in Front and Rear Axle
To achieve higher economy of the original driving scheme with single motor and settled gear ratio, new configurations with different powertrain systems in front and rear axle were designed. Firstly, according to the power and torque required by a micro electric vehicle (mEV) in various drive cycles, the parameters of a small and high power motor were determined. Secondly, for schemeⅠwith dual m...
متن کاملOptimization of Specific Power of Surface Mounted Axial Flux Permanent Magnet Brushless DC Motor for Electrical Vehicle Application
Optimization of specific power of axial flux permanent magnet brushless DC (PMBLDC) motor based on genetic algorithm optimization technique for an electric vehicle application is presented. Double rotor sandwiched stator topology of axial flux permanent magnet brushless DC motor is selected considering its best suitability in electric vehicle applications. Rating of electric motor is determined...
متن کامل