Synergistic recombination suppression by an inorganic layer and organic dye molecules in highly photostable quantum dot sensitized solar cells.

نویسندگان

  • Heping Shen
  • Jianbao Li
  • Lin Zhao
  • Shanshan Zhang
  • Wenli Wang
  • Dan Oron
  • Hong Lin
چکیده

An inorganic layer and dye molecules have synergistically suppressed the recombination in a quantum dot sensitized solar cell (QDSSC), by the design of a structure featured TiO2-CdS-ZnS-N3 (N3: RuL2(NCS)2 (L = 2,2'-bipyridyl-4,4'-dicarboxylic acid)) hybrid photoanode. When fabricated into solar cells, a cobalt complex-based electrolyte rather than an iodine-based one was employed to obtain an impressive photostability for the devices. Raman and Photoluminescence (PL) measurements revealed that not only the CdS QDs were passivated by both the inorganic layer of ZnS and dye molecule of N3, but also N3 served as an efficient hole scavenger for the CdS QDs due to a type-II energetic alignment between the two sensitizers. This role of N3 as an intermediary in hole extraction from CdS QDs to the electrolyte was further proven by the significant photovoltaic performance improvement of the CdS sensitized solar cell after ZnS deposition and N3 co-sensitization. The overall efficiency of the solar cell incorporated with TiO2-CdS-ZnS-N3 film exceeded the sum of the single CdS QDs and N3 dye sensitized solar cells. This enhancement is ascribed mainly to the synergistic recombination suppression by the inorganic layer ZnS and N3 co-sensitization, leading to inhibited recombination and increased electron lifetime, as illustrated by the electrochemical impedance spectroscopy (EIS) analysis.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Restricted charge recombination process in PbS quantum dot sensitized solar cells by different coating cycles of ZnS films

The relatively low power conversion efficiency (PCE) of quantum dot sensitized solar cells (QDSSCs) is attributed to charge recombination at the interfaces. Charge recombination process could be suppressed by coating the QD layer with a wide band gap semiconductor such as ZnS, which acts as a blocking layer between the QDs and hole transport material (HTM). In present study, to improve PCE of P...

متن کامل

SILAR Sensitization as an Effective Method for Making Efficient Quantum Dot Sensitized Solar Cells

CdSe quantum dots were in situ deposited on various structures of TiO2 photoanode by successive ionic layer adsorption and reaction (SILAR). Various sensitized TiO2 structures were integrated as a photoanode in order to make quantum dot sensitized solar cells. High power conversion efficiency was obtained; 2.89 % (Voc=524 mV, Jsc=9.78 mA/cm2, FF=0.56) for the cells that sensitized by SILAR meth...

متن کامل

The investigation on different light harvesting layers and their sufficient effect on the photovoltaic characteristics in dye sensitized solar cell

Titanium dioxide-based nanofibers (TiO2 nanofiber) were prepared by an electrospinning technique. The electrospun composite fibers were synthesized at different concentrations of titanium isopropoxide (25.35, 50.69, 76.05 wt%) and calcinated at different temperatures (450 oC, 650 oC and 850 oC) for 2 h. The diameters of nanofibers decreased by increas...

متن کامل

Preparation of CdIn2S4-CdS nanocomposite via a green route and using them in dot-sensitized solar cells for boosting efficiency

In this work In2S3 and CdS nanoparticles were prepared by a simple hydrothermal method and then annealed at 500 °C for 2 h in an Ar gas until CdIn2S4(CdIS)-CdS nanocomposites were formed. Afterwards, efficiency of the as-synthesized CdIS-CdS nanocomposite in quantum dot-sensitized solar cells (QDSSCs) was evaluated. For this purpose, the as-prepared CdIS-CdS nanocomposites were deposited on TiO...

متن کامل

Influence of TiO2 layer thickness as photoanode in Dye Sensitized Solar Cells

Dye-sensitized solar cells (DSSCs) are categorized as some of inexpensive thin-film solar cells. The basis and foundation of these cells is a semiconductor that consists of an electrolyte and a light-sensitive anode. Titanium dioxide (TiO2) is a semiconductor that plays the role of anode and is the main constituent of these cells. In this paper, we have addressed the functionality and performan...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Physical chemistry chemical physics : PCCP

دوره 16 13  شماره 

صفحات  -

تاریخ انتشار 2014