The algorithms for control of heating massive material
نویسندگان
چکیده
Algoritmus controly ohrievaného masívneho materiálu In numerous technological processes a change on the output follows change on the input pending specific time. This time is called dead time and if this time is too large, it causes problems in the control. This contribution is aimed at analyzing the algorithms of discreet regulation of the systems with dead time. Verified were classical PID regulator and a regulator using Dead Beat method. The control was also tried with Dead interval method. The regulators were tested by simulation and in the electrical laboratory furnace. The task was to control the temperature inside the material heated by furnace power.
منابع مشابه
Various Dosages of BMP-2 for Management of Massive Bone Defect in Sprague Dawley Rat
Introduction: The use of BMP-2 plays an important role in the treatment of extensive bone defect. However, data about the optimal dosage of BMP-2 in the massive bone defect cases is rare. Material and Method: Twenty-five SD rats were randomly divided into a control group ofhydroxyapatite (HA) alone (Group I), HA+BMP-2 1µg/mL (Group II), HA+BMP-2 5 ug/mL (Group III), HA+BMP-2 10 µg/mL (Gro...
متن کاملMulti Objective Optimization on Insulated Residential Roof with Solar Water Heating System Using Grey Relation Analysis (RESEARCH NOTE)
In this work, a multi-objective optimization on novel insulated roof with solar water heating system at low material cost has been carried out through Taguchi based grey relational analysis technique. The novel roofs have concrete, insulating polyurethane, and a channel of water in a metallic pipe tunneling the chromium block. Chromium block is used to conduct more heat to raise the water to re...
متن کاملCompare three different algorithms (MOPSO, SPEA2, NSGA-II) for Multi Objective Optimization of a novel Combined Cooling, Heating, and Power (CCHP) system based on organic Rankine cycle
Recently Debates about Energy and the issue of global warming have led to the use of new energy. One of the best options for this purpose is the use of a new hybrid system of power, heating and refrigeration, with its thermal source of solar and geothermal energy. In the present study, used a combined cooling, heating and power system based on the organic Rankine cycle and the Ejector Refrigera...
متن کاملMethod of Evaluation of Efficiency Improvement Potential for District Heating Systems with Focus on Variable Speed Centrifugal Pumps
The goal of this research is the derivation of method for evaluation of efficiency improvement potential for district heating systems with focus on variable speed centrifugal pump. The effectiveness of the usage of the proportional pressure control is compared with the constant pressure control. This is why, energy calculation analyses have been realized for variable speed centrifugal pumps, an...
متن کاملIRANIAN VERNACULAR ARCHITECTURE: NOTABLE EXAMPLE OF A THERMAL MASS
In some climates, massive buildings made of stone, masonry, concrete, earth and … can be utilized as one of the simplest and most effective ways of reducing building heating and cooling loads. Very often such savings could be achieved in the design stage of the building and with a relatively low-cost. Such declines in building envelope heat losses combined with optimized material configurati...
متن کامل