Linking Deformation and Metamorphism: Pressure-Temperature-time-deformation Paths through Quantitative Microstructural Analysis and Pseudosections
نویسنده
چکیده
منابع مشابه
Metamorphism of Late Neoproterozoic-Early Cambrian Schists in Southwest of Zanjan from the Soltanieh Belt in Northwest of Iran
Late Neoproterozoic-Early Cambrian schists have been occurred in southwest of Zanjan city from the Soltanieh belt. The Soltanieh belt in northwest of Iran is uplifted basement of Precambrian-Paleozoic in main central Iran zone and includes outcrops of Precambrian, Paleozoic and Mesozoic Formations. Late Neoproterozoic-Early Cambrian schists, the oldest stratigraphy unit in the region, consist o...
متن کاملرشد دنبالهای همزمان با دگرشکلی طی دگرگونی مجاورتی ناحیهای فشار کم – دمای بالای منطقه قنداب، فریمان، شمال شرقی ایران
Detailed microstructural analysis has been conducted in the Ghandab metamorphic Complex, which is one of the most important high temperature – low pressure regional contact metamorphism studied areas in Iran. Textural evidence suggests the sequence of growth of minerals with increasing metamorphic grade and during development of a crenulation foliation. The sequence of mineral growth is conside...
متن کاملThe Effect of Deformation Temperature on the Mechanical Properties and Microstructural Evolutions of High Manganese TWIP Steel
In this study, the effect of tensile test temperature (148 to 673 K) on the microstructural evolutions and the mechanical properties of high manganese twinning induced plasticity (TWIP) steel with the chemical composition of Fe- 31Mn-3Al-3Si (wt. %) was investigated. XRD, SEM and TEM were used to study the microstructural evolutions. Stacking fault energy (SFE) of the alloy was also calculated ...
متن کاملFE-Based Analysis of Hot Forming Process Using the Flow Stress Prediction Model
In hot forming process, the workpiece undergoes plastic deformation at high temperature and the microstructure of the workpiece changes according to the plastic deformation. These changes affect the mechanical properties of workpiece. In order to optimize this process, both the plastic deformation of workpiece and its microstructural changes should be taken into consideration. Since material be...
متن کاملQuantitative analysis of thermo-mechanical behavior in 414 stainless steel using flow curves and processing maps
The hot deformation behavior of a typical martensitic stainless steel containing 2.1% Ni was investigated by means of the compression test in the strain rate range of 0.001-1 s-1 and temperature range of 950-1150 °C. The flow behavior of the steel was evaluated using the flow stress curves and flow softening map and by microstructural investigation. Taking into account of the strain effect on t...
متن کامل