Optimization of an erbium-doped fiber amplifier with radial effects

نویسندگان

  • Cheng Cheng
  • Min Xiao
چکیده

Applying an inversing method and a genetic algorithm, two radial distributions, i.e., a core graded-index and erbium-doped concentration, are optimized for an erbium-doped fiber amplifier (EDFA) in a two-level model under single-mode condition and weakly guided approximations. There is evidence to show that the core graded-index has obvious influence on the gain bandwidth of the EDFA, and similarly, the radial distribution of the erbium concentration has effect on the bandwidth, while no effect on the gain. As an example, we provide an optimized single-fiber EDFA with the graded-index and the erbium concentration distribution, which is characterized with a 33.5 dB gain, a 30 nm bandwidth, and a noise figure of 3.55 dB. The broader bandwidth is one of the outstanding advantages over current single-fiber EDFAs with uniform radial distributions. 2005 Elsevier B.V. All rights reserved. PACS: 42.60.Da; 42.55.Wd

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Observation of Raman Gain in Reduced Length of Bismuth Erbium Doped Fiber

Raman amplification of a 49 cm Bismuth oxide (Bi2O3) as a nonlinear gainmedium based erbium doped fiber amplifier (EDFA) is reported in new and compactdesign in near infrared spectral regions. The bismuth glass host provides theopportunity to be doped heavily with erbium ions to allow a compact optical gain fiberamplifier design by using reduced fiber length and the 1480...

متن کامل

Gain, Noise Figure and Efficiency Characteristics of an L-Band Erbium Doped Fiber Amplifier

In this work, the construction of a single stage L-band erbium-doped fiber amplifier which incorporates a short 5.1 m erbium doped fiber coil is described. Gain and noise figure measurements as a function of forward, backward and counter-propagating CW 1480 nm pumping schemes at different pump power levels are presented. Further, the Erbium Doped Fiber Amplifier (EDFA) power conversion efficien...

متن کامل

Experiment on Erbium-Doped Fiber Amplifiers

• Understand the principle of operation of the erbium-doped fiber amplifier (EDFA). • Construct an EDFA and an erbium-doped fiber laser. • Measure and calculate the essential parameters of the constructed EDFA. The basic theories on optical amplification by erbium-doped fibers are presented in this section as preparation for the discussions on noise characteristics and noise reduction methods p...

متن کامل

All-optical clock recovery using erbium-doped fiber ring laser incorporating an electro-absorption modulator and a linear optical amplifier

We demonstrated 10-GHz all-optical clock recovery using an erbium-doped fiber laser incorporating an electro-absorption modulator and linear optical amplifier. Stable clock pulses with peak power of 200 mW and pulsewidth of 6 ps are obtained.

متن کامل

Simultaneous measurement of strain and temperature by use of a single-fiber Bragg grating and an erbium-doped fiber amplifier.

We propose and demonstrate a novel sensor by using a single-fiber Bragg grating that can simultaneously measure strain and temperature with the aid of an erbium-doped fiber amplifier. By using a linear variation in the amplified spontaneous emission power of the erbium-doped fiber amplifier with temperature, we determine the temperature. By subtracting the temperature effect from the fiber Brag...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2005