STUDY OF THE STRUCTURE OF INTERMETALICS FROM Fe - Al SYSTEM AFTER THE HOT ROLLING
نویسندگان
چکیده
M. Jabłońska, I. Bednarczyk, K. Rodak, A. Śmiglewicz Silesian University of Technology, Faculty of Materials Science and Metallurgy, Institute of Materials Science Katowice, Poland This paper presents the results of structure analysis of Fe Al alloys after hot rolling deformation. Microstructure analysis were performed before and after deformation using a scanning transmission electron microscopy (STEM) technique. The detailed quantities research of the structures was conducted using scanning electron microscopy (SEM) equipped with the gun with cold field emission and the detector of electron back scattering diffraction (EBSD).
منابع مشابه
Magnificent Grain Refinement of Al-Mg2Si Composite by Hot Rolling
The effect of chemical composition and the hot rolling operations on the microstructure and mechanical properties of in situ aluminum matrix composite with Mg2Si phase as the reinforcement was studied. It was revealed that the modification by phosphorous results in the rounder (more spherical) primary and secondary (eutectic) magnesium silicide intermetallics. During hot rolling, the primary pa...
متن کاملThe Effect of Cross-Rolling Process on Nanostructure of Al 1050 Alloy
The cross-rolling is a new process that results in significant evolutions in microstructure of the metallic sheets. In this study, an aluminium 1050 sheet was rolled up to 95% reduction in cross directions for ten passes. The rolled samples were investigated by X-ray diffraction (XRD) and transmission electron microscopy (TEM). The rolled samples possess a high dislocation density and ultra-fin...
متن کاملInvestigation of Friction Coefficient Effects on Fishtail Defect in Hot Ring Rolling Process
Hot ring rolling is a highly nonlinear, unsteady-state and asymmetry process which is affected by many parameters. The friction coefficient between the ring ,the driver roll and the idle roll is one of the problems, which has significant effect on the quality of final product. In this study, the effect of these two parameters on hot ring rolling was investigated based on a 3D coupled-thermo mec...
متن کاملHot and Cold Tensile Behavior of Al 6061 Produced by Equal Channel Angular Pressing and Subsequent Cold Rolling
The full annealing AA6061 aluminum alloy was subjected to severe plastic deformationvia the combination of equal channel angular pressing (ECAP) and cold rolling (CR) in order torefine its microstructure and to improve its mechanical properties. According to the results of hotand cold tensile tests, the combination of ECAP and CR significantly affected the final strengthand ductility of studied...
متن کاملSignificance of Heat Conduction Parameter along the Rolling Direction in the Thermal Modeling of the Hot Rolling Process
Obtaining temperature distribution data of slabs under rolling is essential as the mechanical and metallurgical properties of the metal under this process vary with temperature. Using the control volume method, a mathematical model is employed in this study to predict slab temperature in the hot roll process at Mobarakeh Steel Company. The effects of different parameters including the heat resu...
متن کامل