Estimation of Joint Torque and Power Consumption During Sit-to-Stand Motion of Human-being Using a Genetic Algorithm
نویسندگان
چکیده
A model of human lower limb along with body has been drawn having a presumed body height and body mass index. Different ranges of joint angles of human legs and body have been taken to simulate the sit-to-stand motion. The kinematic analysis is done by varying joint angles over time. The dynamic studies have been carried out for different joints. Torque and power consumption have been calculated. Using a genetic algorithm, optimal solutions for joint torque and power consumption have been obtained. The dynamic balance of human body system during sit-to-stand motion has also been maintained while carrying out the optimization. Another attempt has been made in order to get optimum torque and power consumption in minimum time by treating it as a multi-objective optimization problem. Thus, a Pareto-optimal front of solutions has been obtained. © 2016 The Authors. Published by Elsevier B.V. Peer-review under responsibility of KES International.
منابع مشابه
Optimization of Reduction Settings and Inter-stand Tensions for Tandem Cold Mills using Genetic Algorithm
Cold rolling process is a complicated process which can be optimized by changing in variables and settings. This paper presents a set-up optimization system developed to calculate reductions and inter-stand tensions for each stand of a five stand tandem cold mill. The main objective in this optimization is minimization of power consumption. First, by using the analytical method, the equations ...
متن کاملEstimation of Electricity Demand in Residential Sector Using Genetic Algorithm Approach
This paper aimed at estimation of the per capita consumption of electricity in residential sector based on economic indicators in Iran. The Genetic Algorithm Electricity Demand Model (GAEDM) was developed based on the past data using the genetic algorithm approach (GAA). The economic indicators used during the model development include: gross domestic product (GDP) in terms of per capita and ...
متن کاملDesign of a Semi-Active Semi-Passive Assistive Device for Sit-to-Stand Tasks
In this paper a robotic assistive device, aimed at assisting physically impaired individuals when rising from a sitting to a standing position, is presented. We investigate the standing up motion of aged people who requires to power support and typical standing up motion by nursing specialist. It has been shown that the contribution to the joint torques by the gravitational torques is dominant ...
متن کاملOptimal Torque Control of PMSG-based Stand-Alone Wind Turbine with Energy Storage System
In this paper optimal torque control (OTC) of stand-alone variable-speed small-scale wind turbine equipped with a permanent magnet synchronous generator and a switch- mode rectifier is presented. It is shown that with OTC method in standalone configuration, power coefficient could be reached to its maximum possible value, i.e. 0.48. An appropriate control algorithm based on turbine characterist...
متن کاملEfficiency Improvement of Induction Motor using Fuzzy-Genetic Algorithm
In most industrial zones, electric energy is one of the most important energy sources. Since electrical motors are the main energy consumers of industrial factories, consumption optimization in these motors can be considered as a main option related to energy saving. One very effective way to reduce the consumption of these equipment is to use a motor speed controllers or drives. Since the loss...
متن کامل