Feasibility of a Hydraulic Power Assist System for Use in Hybrid Neuroprostheses
نویسندگان
چکیده
Feasibility of using pressurized hydraulic fluid as a source of on-demand assistive power for hybrid neuroprosthesis combining exoskeleton with functional neuromuscular stimulation was explored. Hydraulic systems were selected as an alternative to electric motors for their high torque/mass ratio and ability to be located proximally on the exoskeleton and distribute power distally to assist in moving the joints. The power assist system (PAS) was designed and constructed using off-the-shelf components to test the feasibility of using high pressure fluid from an accumulator to provide assistive torque to an exoskeletal hip joint. The PAS was able to provide 21 Nm of assistive torque at an input pressure of 3171 kPa with a response time of 93 ms resulting in 32° of hip flexion in an able-bodied test. The torque output was independent of initial position of the joint and was linearly related to pressure. Thus, accumulator pressure can be specified to provide assistive torque as needed in exoskeletal devices for walking or stair climbing beyond those possible either volitionally or with electrical stimulation alone.
منابع مشابه
DEVELOPMENT OF A DC MOTOR ASSISTED HYDRAULIC BRAKING SYSTEM FOR AUTOMOTIVE USE
ABSTRACT: Deceleration or stopping the vehicle without any diving and lateral acceleration is essential to develop an effective braking system. The hydraulic braking system with intelligent braking called Antilock Braking system (ABS) and Electronic Stability Control (ESC) has been introduced. However, due to the insufficient human effort, the ABS and ESC to some extent, not function well...
متن کاملA New Framework for Advancement of Power Management Strategies in Hybrid Electric Vehicles
Power management strategies play a key role in the design process of hybrid electric vehicles. Electric Assist Control Strategy (EACS) is one of the popular power management strategies for hybrid electric vehicles (HEVs). The present investigation proposes a new framework to advance the EACS. Dynamic Programming method is applied to an HEV model in several drive cycles, and as a result, some op...
متن کاملFuzzy Method in Feasibility Study of Using Biomass Solar Hybrid Source and Photovoltaic System for Designing a Research Center Building in Smart Grid of Hamedan
In this paper, the electrical consumption of a Research Center Building is derived of the bills, Then with defining of fuzzy Bus Thermal Coefficient objective function for heating, the amount of available heat selling to Research Center Building consumer that is produced by Biomass Solar Hybrid Source is calculated. With the capacity determination of Biomass Solar Hybrid Source to provide Therm...
متن کاملModeling and Fuzzy Control Strategy Design for the Hydraulic Hybrid Refuse Truck
In the present paper, the idea of braking energy regeneration and reusing that energy during acceleration for a refuse truck is comprehended. According to their driving cycle, the refuse trucks have a good potential for braking energy regeneration. On the other hand, hydraulic hybrid is a powertrain with high power density which is appropriate for energy regeneration. In the primary stage of th...
متن کاملA Multi-port High Step-up DC/DC Converter for Hybrid Renewable Energy Application
This paper presents a novel multi-port DC/DC converter which is suitable to be used as the interface of hybrid renewable energy systems. The converter contains three unidirectional power flow ports which two of them are input ports and are connected to two independent energy sources while the third one is the output port that feeds a standalone load. Furthermore, the proposed converter contains...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
دوره 2015 شماره
صفحات -
تاریخ انتشار 2015