Room-temperature continuous-wave operation of Ti:sapphire buried channel-waveguide lasers fabricated via proton implantation.

نویسندگان

  • C Grivas
  • D P Shepherd
  • R W Eason
  • L Laversenne
  • P Moretti
  • C N Borca
  • M Pollnau
چکیده

Fabrication and laser operation of proton-implanted Ti:sapphire buried channel waveguides is reported for the first time to our knowledge. Without any postimplantation annealing of the structures, continuous laser operation near 780 nm was demonstrated at room temperature at an absorbed pump power threshold of 230 mW. Single-transverse-mode laser emission was observed with measured beam propagation factors M(2)(x) and M(2)(y) of 1.5 and 1.2, respectively. An output power of 12.4 mW for 1 W pump power was obtained with an output coupler of 4.6% transmission at the signal wavelength. Higher output powers were measured in waveguides with larger cross sections exhibiting multimode laser emission.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Continuous wave operation of a mid-infrared semiconductor laser at room temperature.

Continuous wave operation of quantum cascade lasers is reported up to a temperature of 312 kelvin. The devices were fabricated as buried heterostructure lasers with high-reflection coatings on both laser facets, resulting in continuous wave operation with optical output power ranging from 17 milliwatts at 292 kelvin to 3 milliwatts at 312 kelvin, at an emission wavelength of 9.1 micrometers. Th...

متن کامل

Designable buried waveguides in sapphire by proton implantation

Buried and stacked planar as well as buried single and parallel channel waveguides are fabricated in sapphire by proton implantation. Good control of the implantation parameters provides excellent confinement of the guided light in each structure. Low propagation losses are obtained in fundamental-mode, buried channel waveguides without postimplantation annealing. Choice of the implantation par...

متن کامل

Continuous-wave Lasers in Polymer waveguides

Channel waveguides based on a polymer, 6fluorinated-dianhydride/epoxy, which is actively doped with a rare-earth-ion-doped complex, Nd(thenoyltrifluoroacetone)3 1,10-phenanthroline, have been fabricated. Photoluminescence peaks at 880 nm, 1060 nm, and 1330 nm have been experimentally observed. By optimization of the fabrication procedure of both, host material and optical structure, continuous-...

متن کامل

AIGaAs inverted strip buried heterostructure lasers

Inverted strip buried heterostructure lasers have been fabricated. These lasers have threshold currents and quantum efficiencies that are comparable to those of conventional buried heterostructure lasers. The optical mode is confined by a weakly guiding strip loaded waveguide which makes possible operation in the fundamental transverse mode for larger stripe widths than is possible for conventi...

متن کامل

Electrically pumped InP-based microdisk lasers integrated with a nanophotonic silicon-on-insulator waveguide circuit.

A compact, electrically driven light source integrated on silicon is a key component for large-scale integration of electronic and photonic integrated circuits. Here we demonstrate electrically injected continuous-wave lasing in InP-based microdisk lasers coupled to a sub-micron silicon wire waveguide, fabricated through heterogeneous integration of InP on silicon-on-insulator (SOI). The InP-ba...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Optics letters

دوره 31 23  شماره 

صفحات  -

تاریخ انتشار 2006